807232

Eufab 11411 - Bike Two Seite 8

8
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
8
Personal injury or property damages caused by protruding parts.
Parts protruding beyond the edge of the vehicle or rack may cause personal
injury or property damage during the journey.
• Only mount parts that do not protrude beyond the edge of the vehicle.
Personal injury or property damage possible due to a damaged
bicycle rack.
Damage to the rack, e.g. by bent parts, cracks or scratches, prevents the safe
operation of the rack.
Property damage caused by hot exhaust gases.
Damages may be caused to the rack or bicycles if the exhaust outlet is close
by.
• Use an exhaust de ector if necessary.
Property damage due to opening tailgate.
The tailgate could hit the bicycle rack and be damaged.
• Switch o the electric tailgate and operate it manually.
• Do not mount the bicycle rack if it is damaged in any way.
• Follow the steps as described in the chapter on „Maintenance”.
Personal injury or property damage possible due to loss of bicycle
parts while driving.
Personal injury or property damage due to loss of the bicycle rack
while driving.
Damaged may be caused by parts that can be lost if they come away from
the bicycle during the journey.
• Remove all parts that may be lost before starting your journey, these
include air pumps, battery-powered lamps, navigation systems, bicycle
computer, tool bags or baskets.
A loose or faulty connection between the bicycle rack and trailer tow bar
can lead to the detachment of the bicycle rack.
• Replace a defective trailer tow bar.
• Clean the trailer tow bar of dirt, dust and grease.
Personal injury or property damage due to overloading.
Exceeding the maximum payload of the bicycle rack and the permitted
supporting load of the trailer tow bar or permitted overall weight may lead
to serious accidents.
• Always observe the speci cations regarding the maximum payload,
permitted supporting load and permitted overall weight of your vehicle.
Do not exceed these speci cations at any time.
Personal injury or property damages caused by increase wind
loads.
The bicycle rack and trailer tow bar may be damaged by too high a wind
load
• Remove all bags from the bicycle before starting your journey.
• Do not use protective covers for the bicycle during the journey.
The general operating permit must be carried in the
vehicle when the rack is mounted.
Do not travel with the bicycle rack empty. Store it in
the boot of your vehicle. This prevents increased fuel
consumption and protects the rack.
The driver is always responsible for ensuring that the
load and the load securing meet the regulations.
Rack table, left half
Rack table traverse
Lock screw M6 x 70
Washer 6 mm
Nut M6
Rack table, right half
5.1.1 MOUNTING THE USHAPED BRACKET
Place the left and right halves of the rack table on an even surface with the
wheel rail openings facing upwards. Secure the rack traverse to the rack
table by feeding the M6 x 70 lock screws from the top through the table and
traverse and screwing into from below with washers and nuts. At this point,
do not yet tighten the nuts. Pay attention to ensure that the screws for the
license holder are on the outside of the rack traverse.
5. OPERATING INSTRUCTIONS
5.1 MOUNTING THE BICYCLE RACK
The bicycle rack must  rst be assembled. Take all of the components out of
the packaging and set them out clearly. Check the scope of delivery. Every
stage is described and clearly shows which components are required for the
assembly of the rack.
Connection
Connect both rack halves with the connection plates and the table. Make
sure that the large, central drilled hole of the connection plate lines up with
the hole of the rack table. Insert the four M8 x 50 hexagonal screws with
washers, from the inside, through the connecting plate and the square
pipe of the rack table. From the outside, place the rack base on the ends of
the screws. In doing so, the mount for the tow bar must be at the bottom.
Secure the base using washers, spring washers and nuts. Now screw the
RESULT
Hexagonal screw
M16 x 90
Hexagonal screw
M8 x 50
Washer 8 mm Nut M8 Spring washers 8 mm
Connection plates
Base
Bottom
… 8 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Eufab 11411 - Bike Two wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info