Bedienungsanleitung Eufy T2120 - RoboVac 15C (Seite 16 von 94) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch)

706237

Zoom out

Zoom in

Vorherige Seite

1/94

Nächste Seite

28 29

English English

- When using a network extender/repeater, make sure the network name (SSID) and

password are the same as your primary network.

- The firewall and port settings of your Wi-Fi router allow RoboVac to connect with

the Eufy servers.

Network Security Requirement

- WPA and WPA2 using TKIP, PSK, AES/CCMP encryption.

- WEP EAP (Enterprise Authentication Protocol) is not supported.

Wi-Fi Channels

- The FCC requires that all wireless devices in the United States operate on the 1-11

wireless spectrum channels.

- Some countries outside North America can use spectrum channels higher than

channel 11. Refer to your local regulatory agency to determine which channels are

accessible.

- A future software release will support access to channels above 11 for users outside

North America. Until then, use channels 1-11.

If you cannot control RoboVac with your smartphone, try the solutions below to solve the

problem. If the problem persists, contact the eufy service center for help.

Wi-Fi Status

Light Cause Solutions

Solid blue RoboVac has connected

to your router, but cannot

access the Internet.

• Check if your router is connected to the

Internet.

• Check with your Internet provider to

see if there is any Internet connection

problem.

Rapidly flashing

blue

RoboVac cannot connect

to your wireless router.

• Check if you have modified your

network name and password.

• Reset Wi-Fi connection if necessary.

Refer to the “Use Your RoboVac with

the EufyHome App > Reset the Wi-Fi

connection” section in this manual.

Slowly flashing

blue

Wi-Fi connection is reset

or has not been set up

before.

• Set up Wi-Fi connection with RoboVac.

Refer to the “Use Your RoboVac with

the EufyHome App” section in this

manual.

• Reset Wi-Fi connection if necessary.

Refer to the “Use Your RoboVac with

the EufyHome App > Reset the Wi-Fi

connection” section in this manual.

Off • RoboVac is turned off.

• RoboVac’s power level

is low.

• RoboVac is in Sleep

mode.

• Charge RoboVac by attaching it to

the Charging Base. Make sure the

main power switch on the bottom of

RoboVac is turned on.

Specifications

Product Model T2120

Input 19 V 0.6 A

Battery Voltage DC 14.4 V

Power Consumption 40 W

Battery Type DC 14.4 V

Li-ion 2600 mAh

Dust Collector Capacity

0.6 L

Cleaning Time Max. 100 mins

Charging Time 300 - 360 mins

Input 19 V 0.6 A

Output 19 V 0.6 A

Customer Service

For FAQs and more information, please visit www.eufylife.com.

@EufyOcial

@EufyOcial @EufyOcial

Anker Innovations Limited

Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eufy T2120 - RoboVac 15C Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Eufy T2120 - RoboVac 15C

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info