Bedienungsanleitung Eurochron WS1080 (Seite 66 von 104) (Deutsch, Englisch)

689520

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

9. Commissioning

a) Outdoor Sensor

The DCF receiver is integrated in the temperature/humidity sensor housing. This leads to much less inter-

ference in DCF reception than in other weather stations.

Observe:

If you have not installed the holder assembled in chapter 8 with the sensors in the outdoor area yet, but

they are still within a building, there may be reception problems (DCF time is not displayed on the weather

station).

 Werecommendthatyourstinstalltheholderandsensorsoutdoorsandtheninserttheincludedbatteries

into the battery compartment of the temperature/humidity sensor.

• Open the battery compartment at the temperature/humidity sensor by pushing the battery compartment lid down-

wards.

• Insert the two included batteries into the battery compartment in the correct polarity (observe plus/+ and minus/-)

and closed the battery compartment again. A red LED in the housing lights up for about 4 seconds and then goes

outagain.WhentheDCFsignalwasrecognised,theLEDashes5timesandthengoesout.

• The DCF receiver in the temperature/humidity sensor now scans for the DCF signal. This may take about 5 min-

utes. Do not move the holder with the sensors during this time.

b) Weather Station

Please note:

The DCF receiver integrated in the housing of the temperature/humidity sensor requires about 5 minutes

at good reception until it has completely received and assessed the data in the DCF signal.

If you insert batteries in the weather station during this time, the weather station may display measured

values for temperature, humidity, wind direction and wind speed after a while, but not DCF time and date

yet.

Just wait for a few minutes until the DCF time and date are sent in addition to the measured values; the

DCF time and date display appears automatically on the weather station then (bottom-most display line).

• Open the battery compartment lid on the rear of the weather station and insert 3 type AA/mignon batteries into with

correct polarity (observe plus/+ and minus/-).

• Alldisplaysegmentsappear brieyontheweather station’sdisplayafter the batteriesareinserted. Thenthe

weather station issues a signal sound.

• Close the battery compartment again.

• The weather station is now scanning for the outdoor sensor’s transmitter signal. Between the display of the indoor

and outdoor humidity, the symbol „ “ for transmitter display is displayed.

Do not touch the weather station touch screen during this time and do not move the weather station.

• After a few minutes, the outdoor temperature/humidity should be displayed, as well as the wind speed, wind direc-

tion and rain volume.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eurochron WS1080 Seite 66

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Eurochron WS1080

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info