Bedienungsanleitung Euroflex Monster SC35 PLUS (Seite 7 von 8) (Englisch)

500321

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

CARPET SLIDER: This attachment clips over the face of the oor brush

preventing the bristles from interacting with the carpet. To use: Clip the

carpet slider onto the oor brush, then attach the oor brush to the

extension tubes. When refreshing carpet or rugs you should vacuum

througly before steaming and then again after steaming to remove

the dirt that is loosened by the steam.

Note: Steam will only refresh carpets / rugs and to kill dust mites. Steam

will not shampoo carpets / rugs.

SMALL BRUSH: When the cotton cloth is used with the small brush, smooth

surfaces can be cleaned such as kitchen cupboards and counter tops,

range hoods and fridge areas. If the soft nylon bristles are used, shower

tiles and screens can be cleaned using the bristles to scrub hard soap

deposits. To use: make contact with the surface being cleaned allow-

ing the heat from the steam to soften and lift the dirt. Wipe the dirt and

excess moisture from the surface with a cleaning cloth.

Tip: a microbre cloth is best for wiping away soap deposits from shower areas and

for high gloss areas.

1. Hook the top front of the caddy over the two hooks on the reverse of the

appliance and push the bottom part of the caddy under the body of the cleaner so

that the holes in the xing lugs match the holes for the plastic screws.

2. Fit the two plastic headed screws provided through the xing lugs into the two

screw holes turning clockwise until hand tight.

TOOL CADDY

FITTING THE TOOL CADDY

2 3

PLEASE NOTE The tool caddy must be tted to the Monster SC35

before the wall storage rack can be used.

IMPORTANT SAFETY MESSAGE When storing your Monster SC35 on

the wall rack, ensure that any tools and accessories in the tool

caddy are not in a dangerous position. In particular the extension tubes could be

a hazard if the rack is situated at eye level.

1. Select your site for the wall rack. Check that there is room for the steam cleaner

in the position you choose and that it will not obstruct doorways or access to other

items stored near by. The cleaner drops down on to the rack so you will need to t

the wall rack with at least 6.5 cm clearance above it. Be certain that the surface

you are xing to is sound and capable of bearing the weight .

2. Hold the wall rack in the correct position (ensuring that it is level – we recom-

mend you to use a level), and using the rack as a template mark the screw hole

positions with a pencil.

3. Use the correct xing for the surface you are tting to the wall rack. A wide range

of xings is available from your local hardware store, to ensure the surface can

support the weight.

4. Screw the wall rack in place using round head or at head screws of the correct

size for the xing method you are using.

FITTING THE WALL STORAGE RACK

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Euroflex Monster SC35 PLUS Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info