Bedienungsanleitung Eurom 1500 Comfort (Seite 8 von 20) (Deutsch, Englisch, Holländisch, Französisch)

540703

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

provided is identified for a brick wall; for another foundation please ask the specialist for

suitable material.

 Check before mounting or the minimum safe mounting distances between heater and

environment are strictly followed. The distance between the bottom edge of the appliance

and the floor must be at least 2,5 meter. There must be a distance of at least 0,5 meter

between the appliance and the ceiling, roof or other cover. If the covers consist of flammable

material (p.e. wood, plaster, canvas etc.), the distance has to be at least 1 meter and if you

focus the radiator upwards, at least 2 meter. There

must be a distance of at least 1,5 meter at each

side between the appliance and walls or the like.

When you install the appliance outside, pay

attention that it doesn’t catch excessive wind load.

 Fix the mounting bracket totally horizontal on the

wall with the three anchor dowels provided. The

short side of the bracket has to point upwards (see

fig.).

 Assemble the appliance onto the mounting bracket

with the two winged nuts, the cable at the

underside of the appliance (see fig.).

 Adjust the desired angle of radiation. The radiator

can turn 115°: from half upside till almost totally

downwards. Pay attention that the radiator doesn’t

focus its heat from a short distance at combustable

materials! The recommended number of degrees to

the mounting wall is 45 ° (see fig.)

 Fasten all screws another time firmly and scheck or

the heater is firmly mounted. Now your infra red

heater is ready for use.

 For personal protection the installation, to which the

EUROM GOLDEN COMFORT is connected, has to

be equipped with an earth fall device (max. 30 mAmp).

Under some circumstances it may be attractive to make a fast connection between the heater

and the main supply, and to operate the heater with a switch. Because the EUROM GOLDEN

COMFORT has a high water tightness (IP65) and for safety reasons, such a connection has to

be made by a qualified electrician.

WORKING

Check for every use:

- or the appliance doesn’t show signs of damage.

- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating duet o wind

or rain could lead to loose.

- or there are no objects, canvas, sun screens etc. are inside the safety distances.

- or the socket you want to use gives the correct tension (220-240V-50Hz) and is grounded.

If everything is all right you can insert the plug into the socket. The infra red heater will start to

work. When you use the appliance for

the first time (or after a long time again), observe it during the first 10 till 15 minutes to be sure

that is works trouble-free.

To stop the heater, take the plug out of the socket and give the heater time to cool down.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eurom 1500 Comfort Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info