43
• Place both hanging brackets (D) over the 2x2 bolts (B), place a ring over each
bolt and screw them until secure with the 4 nuts
(ring + nut = C).
• See diagram for whole installation.
The following applies to all three types
• Screw both wall/ceiling supports loosely between the hanging brackets with the
2 screws (X) and nuts (z) supplied.
• Secure the wall/ceiling supports using both small screws (Y) (RC: and nuts (Z))
in the middle position.
• Select the location for the device, taking all of the instructions into account.
Mark the location for the 4 drilled holes on the wall/ceiling. Ensure that the
device hangs horizontally!
• Unscrew both wall/ceiling supports and secure them firmly to the marked
location on the wall/ceiling. Use wedge bolts for brick or concrete and ask for
advice about attachment materials for any other surfaces.
• Now secure the device firmly to the wall/ceiling supports with the hanging
brackets using both screws and bolts (X and Z).
• The direction of heat from the device can be set to 3 positions. Only change the
setting if the device has cooled down completely and has been disconnected
from the power supply. Secure the direction of heat at the desired angle using
both small screws (Y) and the RC-version with the bolts, rings and nuts (Z).
• Check to ensure that the device is hanging firmly.
• You are advised to ask an electrician to connect the device to the mains and
then operate via a switch. You could also connect an appropriate socket. Make
sure that the electrical cable never gets too hot!
Important! If secured to the wall, the heat can radiate straight out and also around
35° downwards and upwards. Upwards is pointless and is also strictly forbidden!
This could overheat or melt the ceiling, lead to burn marks or even cause a fire.
Water could also get into the device.
Use
Check before each use:
- whether the device is showing any signs of damage.
- whether the device is still secured properly. Wind or gravity could loosen the
attachments over time.
- whether any objects, canvases, parasols, etc. have come within the safe
distances.
- whether the socket you are using provides the correct voltage (220/240V-50Hz).
Using the Outdoor heat panel
If this has all been checked, you can insert the plug into the socket. The device
should now work. Once the device is connected, it will take around 15 minutes to
