Bedienungsanleitung Eurom CK501H (Seite 11 von 28) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

510014

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Description

The CK501H frost shield is an electrical convector heater with

a thermostat and an overheating safeguard. The light is

illuminated when the frost shield is switched on. The CK501H

frost shield is intended to keep small domestic or similar

spaces frost-free. The heater may only be used when

mounted on the wall (never if it is standing up or lying down!)

and only for the purpose for which it was designed.

1 = air outlet grill

2 = pilot lamp

3 = thermostat dial

4 = air inlet grills

Location and Connection

 Remove all packaging material and keep out of reach of children. After removing packaging, check the

appliance for damage or other signs that could indicate a fault/defect/malfunction. In case of doubt, do not

use the appliance, but contact your vendor for inspection or replacement.

 Choose a suitable location for the heater, i.e. at least one metre away from any obstructions, walls or

inflammable materials (see also safety instructions).

 The heater needs to be mounted on the wall. Make sure the wall is solid, totally vertical and non-flammable.

Do not use wooden or synthetic walls! The distance between the bottom of the heater and the floor should

be at least 20 cm. The distance between the heater and the sidewalls should be at least 30 cm and the

distance between heater and ceiling at least 50 cm. Do not mount the appliance directly below or in front of

a socket.

 Loosen both screws on the

suspension bracket and fix the

assembly bracket horizontally to

the wall, using the screws

provided. Slide the heater back

over the bracket and secure

both screws at the side of the

bracket. Make sure the heater and bracket are securely attached and that the heater is

completely horizontal.

 If desired, the CK501H can be permanently connected to the power supply by means

of a suitable junction box (not included). This procedure needs to be performed by a

professional! A disconnection device at a minimum distance of 3mm (e.g. an automatic

power switch, an on/off switch) must be provided for heaters which are permanently

connected to the power supply in order that they may be switched off.

Set-up and Operation

 The frost shield is now ready to use. Insert the plug into a suitable 220-240V-50Hz grounded socket to

switch on the heater. Only connect the heater to an earthed socket!

 To set the desired temperature, turn the thermostat dial to maximum (biggest dot, or clockwise as far as it

goes). Wait for the desired temperature to be reached and then slowly turn the knob until the pilot light goes

off. The desired temperature is now set; when the temperature in the immediate vicinity drops to under this

level the heater will switch on, as will the light. To set the temperature to a higher or lower level, turn the

thermostat dial to either 'maximum' (biggest dot) or 'minimum' (star).

 ns that the frost shield will keep the area frost-free (as

long as the area is not too big or too cold).

 The appliance will function even when set to the lowest level. To fully switch off the heater, you must remove

the plug from the socket (or, in case a 

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eurom CK501H Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info