702543
37
Zoom out
Zoom in
Vorherige Seite
1/96
Nächste Seite
37
numbers on the screen start flashing. The desired temperature can be set with
the + and - button. The set temperature flashes 5x, then the display displays
the ambient temperature again. See figures 12 and 13.
Press the button again to stop the temperature setting. The heater will then
continue to heat continuously without taking into account a set temperature.
Note 1: The heater will start heating when the set temperature is at least 3
degrees higher than the measured ambient temperature.
Note 2: When the set temperature is reached, the heater will stop heating and the
fan will continue to run for 60 seconds to blow the residual heat out of the heater.
The heater will start heating when the set temperature is at least 3 degrees below
than the measured ambient temperature.
Switching off with remote control
7. Press to put the heater on standby, the fan will only cool down for 60
seconds to blow the residual heat out of the device when the heater is in heating
mode: the display counts down the seconds and the fan indicator light stays on.
To switch the heater off fully, press the on/off button to 'o' and
remove the plug from the socket. If the heater is not working, always remove the
plug from the socket.
Security
Anti-tilt protection
The device is equipped with anti-tilt protection that shuts off the device if it
accidentally tips over. As soon as you put it upright again, the heater returns to
standby mode but switch it off first, remove the plug from the socket and check the
heater for damage. In the event of damage or abnormal functioning, do not use it
and take it for inspection/repair!
Overheating protection
The overheating protection switches the device off if it becomes too hot inside. This
can happen if the device is unable provide sufficient heat or draw in enough fresh
air. The cause is usually because the device is (partially) covered, the air inlet or
outlet openings are blocked, or it has been placed to close to a wall, for example.
Once the device has cooled down sufficiently, it should automatically resume
37

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Eurom Complete Room Heater 2000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info