30
Position the feet on the bottom so that the screw holes line up.
Use the supplied self-tapping screws (2x2) to firmly attach the feet to the
heater.
Turn the heater back over.
Make sure that when in operation, the heater is always positioned on a firm,
level, horizontal surface. Never place it on plush carpet.
Unroll the electric cable fully and plug the plug into a suitable, grounded 220-
240V outlet. Only plug in the heater into a grounded outlet! The standby
indicator light (1) will light up. To avoid overload, check that no other equipment
is connected to the same group.
Use and Operation
1. Standby indicator light
2. 750W power
3. 1250W power
2+3 2000W power
4. Heating Working Indicator
5. Timer
6. LED display
7. Function button
8. Standby button
Press the standby button (8). The display shows the temperature setting.
Turn the function button (7) to set the temperature
Press the function button (7) to set the power. The power lights will light up, if
light is lit up, the heater is operating at 750W, if light is lit up the heater
is operating at 1250W, if both are lit up then the heater is operating at
2000W.
By turning the function button (7), you can set the desired temperature higher
or lower. The device has a thermostat and will heat up until the set temperature
is reached. After that, it will stay at the set temperature. Once the temperature
drops 2°, it automatically switches back on.
Attention: the heater saves the set temperature and choice of power; next time
you turn on the heater, the heater will start with the last thermostat setting and
choice of power you used.
