If the cooling function is used for a while, internal ice may form in the Cool Perfect. You will
notice a drop in the unit’s effectiveness as a result. To resolve this situation, switch the unit off
and leave for a while so that the ice can melt. The fan can also be switched on at the highest
setting without cooling.
When the desired cooling or heating temperature has been reached the Cool Perfect will
continue to ventilate, but the compressor will stop.
MAINTENANCE
Always switch the unit off and remove the plug from the socket before carrying out maintenance.
Regular cleaning is vital in order to keep the Cool Perfect in good working order!
The air filters are located behind the grills on the sides of the device. They can be taken out
easily by pulling them forward and then removing them. You clean them by carefully using the
brush attachment on your vacuum cleaner. If they are extremely dirty you may wash them with
diluted soapy water. Allow them to dry thoroughly in the shadow before re-installing them. Never
use the device without filters!
The radiators behind the filters can be carefully cleaned with the brush attachment of your
vacuum cleaner.
The housing can be removed if necessary and cleaned with a damp (not wet!) cloth and a mild
cleaning agent. Do not use paraffin or chemical cleaning agents! Dry afterwards with a soft cloth.
Storage Ensure that the interior of the device is also completely dry before you tidy up at the end
of the season.
PROTECTION
The Cool Perfect is fitted with an overheating safeguard that switches the unit off if it overheats. If
this should occur, you must remove the plug from the socket and leave to Cool Perfect to cool for
at least 30 minutes. Remove the cause of overheating - has the device been (partially) covered?
Is it too close to a wall or another obstacle, preventing it sucking in or dispelling sufficient air?
You can then use the device normally again but keep an eye on it for the first 30 minutes to
ensure there are no further problems. If the device is showing signs of problems or the
overheating recurs, even though there is no obvious assignable cause, ask your supplier or a
recognised electrician to check/repair the unit.
PROBLEMS AND SOLUTIONS
The display will help diagnose what is wrong in certain circumstances.
It will provide the following information code
E0 Short circuit in temperature sensor and printed circuit board. Contact your supplier for
repairs under guarantee.
E2 / E4 The tank is full or the button and cap is not secured properly. Remove the button and
cap from the drainage point on the underside of the unit and allow water to drain away.
Make sure that button and cap are replaced correctly.
DISPOSAL
When the Cool Perfect eventually comes to the end of its useful life and must be
disposed of, it must not be removed with ordinary household waste. Take it to a
special collection point organised by your local council.
Remove the batteries before doing so!
