509999
9
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
9
English
Technical data
Type EK3001
Supply voltage Volt/Hz 230 / 50
Maximum capacity Watt 3000
Settings Watt 0-fan-1500-3000
Insulation class IPX4
Dimensions cm 26 x 25 x 40
Weight kg 5.1 kg
General safety instructions
1. Before using the machine, carefully read this entire instruction manual.
2. Before using your new heater, check it, including cord and plug, for any visible damage. Do not use a
damaged heater, but send it back to your dealer for replacement.
3. This heater is exclusively intended to heat workspaces such as workshops, garages and storage spaces.
Use the appliance for this purpose only.
4. Under the terms and conditions described in this leaflet, the heater can be used in wet or damp indoor
spaces such as bathrooms and laundry rooms. Do not place the heater in the vicinity of taps, bathtub,
shower, pool, fountains or other sources of moisture. Make sure it cannot fall into water and prevent water
from getting into the heater itself. If, at any time, the heater does fall into water, unplug it immediately! Do not
use a heater that has a damp interior but have it repaired. Never immerse the heater, cord or plug in water
and never touch it with wet hands.
5. The supply voltage and utility frequency, specified on the machine, need to match those of the socket that is
used. The electrical installation needs to be protected by a residual current device (max. 30 mAmp).
6. Fully extend the cord before plugging in the heater. Make sure it does not come into contact with any part of
the heater and prevent it from heating up any other way. Do not run the cord underneath carpeting; do not
cover it with mats, carpet strips or similar and make sure it is not placed in any passageways. Make sure the
cord cannot be stepped on and that no furniture is placed on top of it. Do not lead the cord around sharp
corners and do not roll it up too tightly after use!
7. If possible, do not use an extension cord, as this poses the risk of overheating and fire. If the use of an
extension cord is unavoidable, then make sure it is an undamaged, approved extension cord with a minimum
diameter of 2.5 mm², suitable for a minimum permissible power of 3500 Watt. To prevent overheating, always
fully extend the cord!
8. To prevent the circuit overloading and fuses being blown, make sure no other appliances are connected to
the same socket or wired to the same electrical circuit as the heater.
9. Do not use the heater outdoors and do not use it in spaces smaller than 9 m².
10. A heater contains hot and/or glowing and sparking components. Do not, therefore, use in areas where fuels,
paint, flammable liquids and/or gasses etc. are stored.
11. Do not place the heater near, under or directly opposite a socket and do not place it near an open fire or
other heat source.
12. Do not use the heater near or directly opposite furniture, animals, curtains, paper, clothes, bedding or other
inflammable objects. Keep them at least 1 metre away from the heater!
13. Never cover a heater! The heater’s air inlets and outlets should never be obstructed in any way, so as to
prevent the possibility of fire. Never use the heater to dry clothes and do not place anything on top of the
heater. Do not place it on soft surfaces such as beds or deep-pile carpets, as they can block openings.
14. Make sure that the air around the heater can circulate freely. Do not place the heater too close to walls or
large objects and do not place it under shelves, cupboards, and similar.
15. Prevent foreign objects from entering the heater via the venting or exhaust openings as this may lead to
electric shock, fire or damage.
16. Never leave the heater unattended when switched on. Always switch if off before removing the plug from the
socket. Always unplug the heater when not in use! Pull on the plug to remove from the socket, never pull on
the cord.
17. Always switch the heater off, unplug it and leave to cool down before:
- cleaning the heater
- carrying out maintenance to the heater
- touching or moving the heater. Use the handle for this!
18. This machine gets hot when it is in use. To prevent burns, do not let bare skin come into contact with hot
surfaces.
9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Eurom EK3001 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info