Bedienungsanleitung Eurom GOLDEN 2000 AMBER SMART met app (Seite 18 von 76) (Deutsch, Englisch, Holländisch, Dänisch, Französisch)

591723

Zoom out

Zoom in

Vorherige Seite

1/76

Nächste Seite

The following applies for all options:

 However you install the GOLDEN AMBER SMART, always lead the electrical cable

directly away from the heater. It may not become hot!

 Adjust the desire radiation angle of the device. Do this by undoing both Allen screws

slightly using the Allen key. Make sure you secure them again once you have made the

adjustments! The heater can rotate through approximately 90° - with wall fastening

from 30° upwards to approximately 60° downwards. When adjusting the angle ensure

that the radiator does not radiate heat onto flammable materials from a short

distance!

 Fasten all screws another time firmly and scheck or the heater is firmly mounted. Now

your infra red heater is ready for use.

 For personal protection the installation, to which the EUROM GOLDEN 2000 AMBER

SMART is connected, has to be equipped with an earth fall device (max. 30 mAmp).

Under some circumstances it may be attractive to make a fast connection between the

heater and the main supply, and to operate the heater with a switch. Because the

EUROM GOLDEN 2000 AMBER SMART has a high water tightness (IP65) and for safety

reasons, such a connection has to be made by a qualified electrician.

WORKING

Check for every use:

- 

- or the appliance still is fastened firmly. Mechanical bearing pressure, oscillating duet o

wind or rain could lead to loose.

- or there are no objects, canvas, sun screens etc. are inside the safety distances.

- or the socket you want to use gives the correct tension (220-240V-50Hz) and is

grounded.

If everything is all right you can insert the plug into the socket.

The Golden 2000 Amber Smart has a remote control that works with two batteries: AAA,

1.5V.

While using, point the remote control to the receiving point of the heater. If there are

obstacles between remote control and the heater, it will not work!



"I" (on); The red light on the reception point will go on.

he ON

button The device will

start working on the maximum output (2000W).

 Choose another setting by pressing one of the

three buttons:

- Low = 660 Watt

- Med = 1320 Watt

- High = 2000 Watt

           e

remote control. Then turn it off by pressing the on/off-

switch (5) 

outlet. Allow the heater to cool down.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eurom GOLDEN 2000 AMBER SMART met app Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info