THE SMELL OF GAS
An odour is added to gas to allow you to tell if there is a gas leak. Gas is heavier than
air; so try to smell the gas right above the floor.
Immediately take measures if you smell gas!
Immediately shut off the gas supply.
Don’t do anything to cause sparks or fire to prevent inflammation of the gas. Do not
switch electricity on or off, do not light matches, lighter or the like and do not use your
telephone.
Get everyone out of the vicinity of the gas source and give the gas ample time to air
out. Stay nearby during that process. If you still smell gas or have doubts about the
situation, contact the fire department.
Have a gas leak repaired by qualified people.
Operation:
1. Check the heater for damage or defects. Do not use
a damaged heater, but contact your supplier.
2. Make sure to use undamaged, full gas bottles with
propane or butane, suitable for use.
3. Select a place for the heater that meets all the
safety instructions and place it on a level, stable,
horizontal surface with non-flammable material. Do
not plug it in and the set the power switch to O (off).
4. Firmly attach the gas hose with suitable tools to the
pressure regulator (left screw threads!)
5. Remove the protective cap and attach the gas
supply hose to the device (left screw threads!).
Firmly screw on the nut with suitable tools for
unproblematic gas supply.
(Diagram 1)
6. Connect the pressure regulator to the gas bottle.
Firmly screw the nut on so that no gas leakage can
occur. Make sure when you install the gas bottle that
the gas hose is not bent or kinked. Avoid turned and
pulled tension.
7. Check that the device is correctly attached to the gas
bottle and perform a complete gas leakage test (see
the description below in this booklet).
8. When you’re sure everything is in order, open the
gas tap. (Diagram 2).
9. Now insert the plug into the socket. Then set the
power switch to I (on) (Diagram 3). The ventilator will
start running.
10. Wait until the ventilator is running steadily and
stable. Now press the right-hand button of the gas
valve and keep it pressed down for 10 seconds.
