Bedienungsanleitung Eurom LO 10.100H (Seite 10 von 24) (Deutsch, Englisch, Holländisch, Französisch)

509984

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

Position

Excess moisture will travel throughout your home, in the same way that cooking smells waft

to every room in the house. For this reason, the dehumidifier should be positioned, so that it

can draw this moist air towards it from all over the home.

Alternatively, if you have a serious problem in one area you can begin by positioning the

dehumidifier close to this area and later moving it to a more central point.

When positioning the dehumidifier, ensure that it is placed on a level surface and that there is

a minimum of 10 cm (4") of space on either side of the unit to allow for efficient airflow.

This dehumidifier is fitted with castors for extra mobility, if you move the unit, it should first be

switched off and the water tank emptied.

We do not recommend the use of an extension lead, so please try to ensure that the unit is

sufficiently close to a fixed mains socket. If it is necessary to use am extension lead, please

ensure the diameter of the wires of the cable is at least 1 mm2.

When the dehumidifier is in operation, outside doors and windows should be closed when

necessary for most efficient use.

Operation

1. Plug the unit into a correct mains socket. (Please refer to the rating label for correct

voltage/frequency.)

2. Turn ON/OFF button & humidity controller clockwise

away from the OFF-position. As soos as the present

humidity-level is passed, the compressor will start to

work. The indicator will turn into green.

3. Set the ON/OFF-button & humidity controller to the

required humiditylevel level (the intensity of humidity

extraction is increased clockwise). When the required

humidity is reached, the humidifier wil stop automaticly.

For continuous working, set the humidistat to position

'MAX'.

4. To turn off the unit, turn ON/OFF button back to ‘OFF’.

Unplug always after use.

Drainage

While the water tank is full, the compressor will stop for self-protection and the water full

indicator will turn into red.

To move the water tank, pull it out squarely from the unit.

After empting the water tank, place the water tank into space. Make sure it is properly

positioned, in order for the 'water full' sign to go out and your dehumidifier is operating.

Please note: in case, the water tank has not been positioned well, the water full indicator will

turn into red. The equipment does not work.

Continuous drainage

When the dehumidifier is operated at very high humidity levels, the water tank will require

more frequent drainage. In this situation, it may be more convenient to set the unit up for

continuous drainage with the following procedures:

1. Pull out the water tank.

2. Connect the drain hole with water tube of inner diameter: 9mm. Please note: the water

tube is not supplied with the unit. Lead the tube down into a drain or a big container.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eurom LO 10.100H Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info