Bedienungsanleitung Eurom LO50 (Seite 18 von 28) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

591699

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

If the air humidity is set to less than 30%, the device will continuously dehumidify.

The display will show "CO”.

Press the ON/OFF button again in order to switch the device off. The device will

come to a halt and all of the lights will go out. The device will retain its settings as

long as the power is connected. If you remove the plug from the socket, the settings

will be deleted from the system unless the memory function has been activated.

Note:

 If the set humidity is higher than the actual humidity, the device will not come on.

 If you are dehumidifying, the fan motor and the compressor will run for at least

three minutes before the compressor starts. The compressor may not be restarted

within three minutes of switching the device off. It is, therefore, possible that the

motor will not immediately respond to being turned off or on!

 When the temperature is low, keep an eye on whether the device needs to defrost.

When defrosting, the relevant light will come on and the fan will run but the

compressor will automatically switch off.

 If you press the memory button, the system will retain the set humidity level even if

there is a power failure. Once the power supply has been restored, the device will

start to work according to the previously entered settings.

 The display will show a humidity level of 30% to 90%.

 Remove the plug from the socket if you do not plan to use the device for an

extended period.

 Only LO50: If the water reservoir is full, the light will come on and the compressor

and fan will automatically shut down. You will also hear a beep. If you do not drain

the reservoir, the beep will be repeated every 5 minutes. Only once the reservoir

has been emptied can the device be used again.

 Only LO50: You can install a continuous drain by removing the reservoir, taking

the rubber bung out of the base of the reservoir and connecting a hose to this

outlet. Then replace the reservoir and run the hose from the device (downwards)

to a suitable drainage point.

USE

 In order to avoid damaging the compressor, never place the dehumidifier on a

slope of over 45°.

 The device works between 5°C and 32°C.

 When being used, the compressor will emit heat which can increase the ambient

temperature by between 1 and 3°C. This is perfectly normal.

 If the indoor temperature is lower than 10°C and air humidity is pretty low, you will

not need to use the device.

 Ensure that there is at least 10 cm of free space between the air inlet and the

outlet opening and any solid objects, e.g. a wall.

 Try to ensure that the room is as well sealed as possible in order to improve the

dehumidification result.

CLEANING

Too much dust on the filter will impact upon the device’s ability to dehumidify. Clean

the filter regularly (at least once a month); if the device is placed in a dusty

environment, you should clean it weekly or even daily. To do so, remove the front

panel and take the filter out. Remove the loose dust by carefully knocking the filter.

Then vacuum the filter gently or wash it in lukewarm water with a little, mild soap.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eurom LO50 Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info