level. The device will keep heating until the set temperature of the Wi-Fi thermostat is
reached.
It is possible to connect multiple devices to a single Wi-Fi thermostat. All the connected
devices will switch on- and off simultaneously.
To use the Wi-Fi thermostat:
1. Connect the Wi-Fi thermostat to a power outlet.
2. Download the Eurom Smart App on a (mobile) device.
3. Open the Eurom Smart App.
4. Add the Wi-Fi thermostat and other devices to the Eurom Smart App.
5. Go to the device(s) and press the Pairing button to pair the device(s) to the
Wi-Fi thermostat.
The device is connected to the Wi-Fi thermostat. The G-sign illuminates in the Eurom Smart
App and on the device. Now you can enjoy the optimized comfort level of permanent electric
heating.
Temperature calibration (Optional)
When the device is mounted on the ceiling, the internal temperature sensor
(Figure 3, pos. 4) is not able to measure the temperature in the room correctly
due to the fact that heat rises. Therefore, it is absolutely necessary to calibrate
the device panel when it is mounted on the ceiling.
Calibrating the device
1. Set the desired temperature to 45 °C (max. temperature).
2. Let the device heat without interruptions for 120 minutes.
3. Place a digital room thermometer (not included) at a central place where the desired
temperature should be achieved; recommended is 150 cm from the floor.
4. After 120 minutes, calculate the difference between the external thermometer and the
temperature shown on the display of the heater (press any button to make it reappear).
For example: if the display shows 36 °C and the thermometer 20 °C, then the calibration
number is 16.
5. Press the Calibration button on the remote control; a number appears on the display.
6. Press the Plus or Minus button to select the calibration number, from 00 to 25. In our
example this is 16.
7. Press the OK button; the calibration number is now set. The temperature measurement
on the heater is now corrected with the set calibration value.
8. Set the ON/OFF switch to the OFF position (Figure 11, pos. 2) to activate the calibration
process. When the calibration value is changed, the device has to be turned off and then
on to active the new calibration value.
Calibration mode
• Every time the device is turned on and starts heating, the calibration process will start.
The device display will show CL and the Eurom Smart App will show Calibration in
progress. The calibration process uses the calibration number to gradually adjust the
