Press SPEED to select the desired air speed (low, medium or high).
When operating in the ‘cooling’ and ‘dehumidification’ modes, the device will occasionally stop
to allow the radiators to defrost. The device will start again after several minutes. DO not use
substances to accelerate this process and do not change the settings!
If you set the apparatus to ‘cooling’ or ‘dehumidifying’, it will continuously operate unless:
The room temperature becomes lower than the set temperature.
The timer is set to a final time.
Timer:
The Timer button allows you to automatically start or stop the air conditioner at a set time.
Automatic starting: Switch the device on and set the function (MODE) and temperature. Now
switch the device off again. Press the timer button and choose the moment that you would like it
to start working using the temperature buttons: each time you press Λ (up) the hour will
increase, each time you press V (down), the hour will decrease. If, for example, the display
shows 5 hours, the air conditioner will switch on in 5 hours.
Automatic stopping: the air conditioner is on. Press the timer button and choose the moment
that you would like it to stop working using the temperature buttons: each time you press Λ (up)
the hour will increase, each time you press V (down), the hour will decrease. If, for example, the
display shows 2 hours, the air conditioner will switch off in 2 hours. The timer can be set to
between 1 to 24 hours.
Swing
Pressing the SWING button during operation will make the flaps (and thereby the air stream)
move up and down. Press again to stop the swing action.
Sleep
Select the ‘cooling’ MODE (COOL) and set the desired temperature.
Press the ‘SLEEP’ button – the device will automatically increase the desired temperature by
one degree after one hour, and by a second degree after a second hour. The device will
continue to operate at this setting.
Cancel the command by pressing ‘SLEEP’ again.
Water outlet
During the cooling process, the device
removes water from the air. This largely
evaporates but any excess water is
collected in the water reservoir. If the water
reservoir in the device is full, the
compressor and the motor will stop
automatically and the ‘water tank full’ light
(W.F.) will come on. In this event, switch
the air conditioning unit off and remove the
plug from the socket.
Empty the water tank by unscrewing cap A
off the water drainage point and emptying
the tank into a pit or a container or similar
vessel. Remember to screw the cap back
on to the drainage point afterwards!
You can then use the air conditioner as normal again.
