45
Before using the air conditioner, check:
That it has been installed according to safety instructions
That it is not damaged or broken
That the electrical socket that you wish to use has the same voltage as is given
on the unit’s specification plate (220-240V~50Hz)
That no other devices are connected to the same socket
If this has all been checked, you can insert the plug into the socket.
Switch the device on with the ‘power’ button.
Cooling function
Press the ‘Mode’ button until the ‘Cool’ lamp is shown on the display.
The display shows 25°C.
Set the required temperature with the Temp+/Temp- button. The display shows
the configured temperature. The temperature can be set between 16 and 31°C.
Press the ‘Speed’ button to set the ventilator speed at low or high.
Observe an interval of at least 3 minutes between every on/off.
Dehumidification function
Press the ‘Mode’ button until the ‘Dehum’ lamp is shown on the display.
Check if the water discharge high is connected correctly.
The display automatically shows 2°C below the room temperature.
The temperature cannot be changed.
The ventilator speed is automatically set to normal.
Observe an interval of at least 3 minutes between every on/off.
Ventilation function
Press the ‘Mode’ button until the ‘Fan’ lamp is shown on the display.
The display shows 25°C.
Set the power to low or high with the ‘Fan Speed’ button.
The temperature cannot be changed.
Timerfunction
Automatic start:
First set at which temperature and in which mode (cooling, dehumidifying or
heating) you want the air conditioner to start.
Switch off the air conditioner using the <On/Off> button. Now the air conditioner
is in the stand-by position.
Press the <Timer> button.
Using the <Up> and <Down> buttons, set the number of hours after which the
air conditioner has to start (1-24 hours).
Press the <Timer> button once again. The display of the air conditioner shows
the set number of hours.
The air conditioner will automatically start with the entered settings after the
lapsing of the set number of hours.
Automatic stop:
Press the <Timer> button while the air conditioner is operating.
