Safety
The PAC7.2 c.q. PAC9.2 is fitted with an overheating safeguard that
switches the unit off if it overheats. If this should occur, you must
remove the plug from the socket and leave the equipment to cool for
at least 30 minutes. Remove the cause of overheating - has the
device been (partially) covered? Is it too close to a wall or another
obstacle, preventing it sucking in or dispelling sufficient air?
You can then use the device normally again but keep an eye on it for
the first 30 minutes to ensure there are no further problems. If the
device is showing signs of problems or the overheating recurs, even
though there is no obvious assignable cause, ask your supplier or a
recognised electrician to check/repair the unit.
CLEANING AND MAINTENANCE
Note! Before cleaning or carrying out maintenance work on the air
conditioning unit, always switch off and remove the plug from the
socket! Regular cleaning is vital in order to keep the unit in good
working order!
Cleaning the housing
Use a soft, damp cloth to wipe the housing.
Never use aggressive cleaning products, petrol, detergent,
chemically-impregnated cloths or other cleaning solutions. These
could damage the housing. Never spray the unit and ensure that
water never penetrates the device! Dry the unit with a soft cloth.
Cleaning the filters
Clean the filters once every two weeks; a unit with dirty filters will
never work properly. The filters can be found behind the air inlet
grilles on the sides and at the rear. You can easily open these grilles
and remove the filters. Use a vacuum cleaner or gently beat the filter
to remove loose dust and dirt. Rinse the filter with tepid water (not
hotter than 40°C) with a mild, neutral cleaning product. Let the filters
dry thoroughly in the shade before replacing in the unit. Take care!
Never use the air conditioning unit without the filters!
End of season cleaning
If the device is to be stored for a long period, you must take the
following measures!
Remove the condensed water. Run the unit for a few hours on fan
function so that the unit is completely dry inside.
