Electrical safety:
The air conditioning unit is only suitable for indoor use.
Only use the plug that is installed on the device in the factory and
no other form of connector!
The appliance shall be installed in accordance with national
wiring.
Before use, check whether the socket voltage that you will be
using corresponds to the specification plate on the unit. Damage
caused by incorrect voltage is not covered by the guarantee!
If the air conditioning unit is not in use or you are cleaning or
carrying out maintenance on it, turn it off and remove the plug
from the socket. Always turn off first and then remove the plug!
Also, when you are going to use the device: first insert the plug
into the socket, then switch the device ON and then use the
control button!
Do not use the air conditioning unit in a damp or wet environment
and never splash water, oil or any other liquid onto the device.
Avoid the use of extension cables if you can. If this is
unavoidable, use a cable with sufficient capacity (at least 3 x 1.5
mm²) and do not let it cross any walking routes!
Do not move the unit by tugging on the electric cable and never
remove the plug from the socket by pulling the cable.
Do not use the unit if the electrical cable, plug or device is
damaged or broken. The device, plug and/or cable must be
repaired/replaced by an electrician or another suitably qualified
person. Repairs by unqualified persons will result in the guarantee
becoming null and void and could lead to dangerous situations!
Safety in relation to coolant R290:
Read these warning carefully.
This device contains the coolant R290. R290 is a coolant that
complies with the relevant European Directives. Never perforate
the coolant circuit. R290 is flammable (GWP 3)!
Never use substances other than those recommended by the
manufacturer for the defrosting process.
This device must be used and stored in a room that does not
contain sources of ignition, such as open flames or gas and
electrical devices in operation.
Do not perforate any of the components of the cooling circuit and
do not set light to the device.
