Bedienungsanleitung Eurom Safe-t-Heater StH2000T (Seite 17 von 24) (Deutsch, Englisch, Holländisch, Französisch)

591463

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

 Timer. Push the button the number of hours after which the heater must switch itself

off (from 0 to 8 hours).

 Thermostat buttons. After

pushing, “AUTO” is shown in the

display. You can now set the

desired temperature, from 15 to

35°C. With ‘+’ you increase the

desired temperature, and with ’-‘

you decrease the desired

temperature. The display shows

the set temperature for 3 seconds

and then switches back to the

ambient temperature. When the temperature drops to more than 2° below the desired

temperature the heater will operate at 1200W. When it drops to more 3° below the

desired temperature, the heater will operate at 2000W. If the ambient temperature is

higher or equal to the set temperature, the heater will switch off.

 Pushing the ON/OFF and ventilator button again simultaneously will switch off all

functions. The ventilator will then cool down for 30 seconds. Then switch the main

switch to 0 and pull the plug out of the socket.

 The display shows all set functions.

Attention! The heater remains hot for some time after use!

Remote control:

 Place 2 x AAA batteries in the compartment in the correct

manner and close it.

 The buttons on the remote control work in the same

manner as those on the control panel.

 Ensure that there are no obstacles between the remote

control and the receiver on the heater!

Safety features

The heater is fitted with a tipping safeguard which automatically shuts off the appliance if it

inadvertently falls over. When the heater is returned to its upright position, it will resume

functioning as normal but, before reusing, switch off, unplug and check for damage. Do not

use the heater if it is damaged or malfunctioning, but have it inspected/repaired!

In case of internal overheating, the overheating safeguard will switch the heater off. This

may occur if the heater cannot give off enough heat or if it cannot draw in enough fresh air.

As mentioned above, this is generally caused by (partially) covering the heater, obstructing

the air intake and/or outlet grills or installing the heater too close to a wall or something

similar. When the overheating safeguard switches the heater off, you must then switch off

by means of the operation panel and main switch. Unplug and allow the heater to cool

down. Remove and/or amend the cause of overheating and use again, as normal. If you

cannot find a cause and overheating recurs, stop using the heater, and take it in for

inspection/repair.

Cleaning and Maintenance

Keep the heater clean. Deposits of dust and dirt in the appliance are a common cause of

overheating so these should be removed regularly. Switch off the heater, remove the plug

from the socket and allow the heater to cool down before cleaning or carrying out

maintenance work.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eurom Safe-t-Heater StH2000T Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info