Bedienungsanleitung Eurom SHOE-DRYER 350 (Seite 12 von 32) (Deutsch, Englisch, Holländisch, Französisch, Schwedisch)

510033

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Location and Connection

 Remove all packaging material and keep out of reach of children. After removing packaging,

check the appliance for damage or other signs that could indicate a fault/defect/malfunction. In

case of doubt, do not use the appliance, but contact your vendor for inspection or replacement.

1 = drill hole 2 = plug 3 = screw 4 = screwdriver 5 = attachment block

 Select a suitable place for the device, taking into account the safety instructions. The BK2002T

has to be hung from a wall and therefore may not be used in a lying, leaning, hanging or standing

position! The wall on which the device is hung has to be firm, flat and perfectly vertical and made

from non-inflammable material that cannot melt. Hang the shoe dryer in such a position that the hoses

are able to hang downwards freely and without any kinks. The ideal position is generally at a height that the

hoses do not quite touch the floor, then they can easily be inserted into shoes/boots (drill holes 96 cm above

the floor).

 Drill 3 holes in the wall at the selected spot: 2 horizontal to one another with a distance of 19 cm and one 23

mm higher at an equal distance to the two other holes (picture B). Insert plugs into the holes and insert

screws into the first two holes (picture C). Leave the screws protruding by 5 mm (picture D).

 Hook the shoedryer using the suspension eyes over the screws and pull the shoedryer downwards (picture

E). Secure the shoedryer by screwing the attachment block into the third screw hole: the attachment block

which has a hole in it to be placed against the wall, with the flat square pointing downwards, holding the

heater securely (picture F).

Switching on and operation

 

 Fully unwind the electric cable and insert the plug into a suitable 220/240V socket.

 Place the shoes/boots that are to be dried underneath the appliance and insert the drying hoses into the

boots/shoes. A maximum of 4 items can be dried at the same time. If you only have two items, if the size

permits this, you can place two hoses in one shoe/boot. However, make sure that the warm air that is blown

out is then able to escape again; therefore the hoses must not be inserted too tightly into the boot/shoe,

otherwise the appliance may overheat!

 By now turning the ON/OFF button anticlockwise to ON, you switch on the appliance. It will draw in air from

the rear, heat this up in the appliance, blow this out through the hoses which will dry out the shoes/boots.

During operation, the indication light will be illuminated.

 You turn off the appliance by turning the ON/OFF button clockwise to OFF.

Timer:

The heater is equipped with a timer. When you wish to use that, do not turn the ON/OFF button to ON, but from

the OFF position clockwise to the required number of minutes of operation (max. 120). The heater will now switch

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eurom SHOE-DRYER 350 Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info