Bedienungsanleitung Eurom TH2003 S quartz (Seite 10 von 36) (Deutsch, Englisch, Holländisch, Dänisch, Französisch)

591739

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

INSTALLING THE HEATER

Wall mounting:

 The housing of the heater (1) must be at least 30

cm from the ceiling, 50 cm from side-walls and 1.80

m above the floor.

 The patio heater must be affixed to a sturdy wall

made of stone or cement. Never attach to walls

made of wood or other flammable material! Attach

using the bracket supplied; do not use any other

supports or attachments!

 Drill four holes in the correct places for the plugs

and attach the wall support to the wall using the

screws. The curved part of the plate must be

uppermost and the ‘keyhole’ must be located at the

bottom of the support. The wall support must be

horizontal.

 Hang the heater onto the wall support. The bracket

at the back of the heater unit must fall into the curved part of the wall support; the attachment

screw (7) must be placed into the round part of the ‘keyhole’ on the wall support and then

pushed gently downwards until the patio heater is firmly affixed.

 Check that the patio heater is attached firmly and fully horizontally before use.

Assembling the stand (only S version):

 Place the bottom section of the stand (9, with the fastening plate) on the base (8), in

such a way that the screw holes are aligned. Insert the 3 bolts through the double holes and

tighten them firmly. Place the protective cover over the screw connection (for that reason,

remove the cable holder for a moment)..

 Push the central section of the stand (10) over the bottom part (9) and fasten it in place

with one of the screws. You then attach the top part of the stand (11, with the compression

coupling) to the middle section in the same manner with a screw.

 Insert the thinner, adjustable section of the stand (12) as far as you wish into the grey

part of the compression coupling on top of the stand. Slide the locking ring down over the

thin section of the stand and screw it firmly to the grey compression coupling.

 Unscrew the mounting screw (7) almost completely out of the mounting bracket. Place

the head of the terrace heater over the top of the adjustable stand section in such a way that

the screw falls precisely into the hole in the stand. Now tighten the screw firmly (the screw

must disappear into the thin section of the stand and may not protrude!). The thin section of

the stand can rotate 360°, enabling the head of the terrace heater to point in any direction.

The electrical cable can be secured in the cable holders on the stand.

Check that all connections are completely secure and that the terrace heater is securely

positioned before using it.

The terrace heater must be placed at a distance of at least 1 metre from the nearest wall.

The box with the radiator lights must be at least 30 cm from a ceiling and 1.80 metres

above the ground. The terrace heater must be placed firmly on an even and completely

horizontal surface.

PATIO HEATER FUNCTIONS

 Point the head of the terrace heater in the correct direction.

 If the terrace heater is fitted with a base the height of the heating head can be adjusted by

unscrewing the locking ring, pushing the curved section higher or lower, and then securing it

again.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eurom TH2003 S quartz Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info