Bedienungsanleitung Eurom THG12000 RVS (Seite 21 von 32) (Deutsch, Englisch, Holländisch, Französisch)

591712

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

- 21 -

Step 6

6-5 Tilt the gas bottle container and allow it to rest on the

frame.

6-6 Close the pressure regulator on the gas bottle and screw

the fastener on securely with the adjustable monkey

wrench.

6-7 Place the gas bottle within the frame.

6-8 Let the container drop over the frame.

T = pressure regulator U = gas bottle

Your patio heater is now assembled.

In order to conduct a comprehensive leak test: cover the entire

gas ‘pathway’ with the soapy solution and check for leaks. Pay particular attention to connection points

and risky areas!

Only when you are 100% sure that there are no gas leaks can you use the patio heater.

Please refer to chapter: Checking for leaks.

LOCATION AND INSTALLATION

 The patio heater is intended for outdoor use. Never use it in areas where this is a risk of explosion,

such as rooms where gas or other flammable substances are stored.

 Make sure, at all times, that there is sufficient air ventilation.

 Find a location a good distance away from flammable materials: keep a free space of at least 45 cm

on top and 60 cm at the sides.

 Place the patio heater on a sturdy, stable, flat and horizontal surface.

 In order to protect the patio heater in high winds, anchor it with pins into the ground or screw it into the

surface. The base of the patio heater has attachment points for this purpose. Pins/screws are not

supplied but must be suitable for the surface concerned.

GAS REQUIREMENTS

 Only use propane or butane gas.

 The maximum entry pressure on the gas regulator may not exceed 10 bar.

 A minimum supply pressure of 28 mbar is required.

 The gas regulator and hose must fulfil legal requirements.

 The hose has to be 134 cm. long and the type EN1763-1-class 2-6:3-20bar propane / butane with

screwcoupling.

 The installation must conform to legal guidelines for storage and use of liquid petroleum gases.

 A dented, rusted or damaged bottle of gas could be dangerous and must be checked by the gas

supplier. Never use a gas bottle that has a damaged valve.

 Never connect a gas tank that does not fulfil regulations to the patio heater!

CHECKING FOR GAS LEAKS

The connections on the patio heater are checked for leaks in the factory before shipping. In order to

make sure damage has not occurred during transport or as a result of high pressure, another complete

leak test must be carried out during installation.

 Carry out the check with a full gas bottle.

 Set the control button to OFF.

 Make a soapy solution using one part liquid soap to one part water.

 Apply the soap solution to the whole system, particularly the connections, using a spray bottle, brush

or cloth.

 Open the gas supply. If there is a leak, you will see soap bubbles forming.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eurom THG12000 RVS Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info