Bedienungsanleitung Eva Calor Hydro 27 kW (Seite 8 von 55) (Englisch)

668828

Zoom out

Zoom in

Vorherige Seite

1/55

Nächste Seite

Fig. 5

Table 2

Roof pitch ? [°]

Horizontal width of

the zone of reflux

from the axis of the

ridge A[m]

Minimum height of

the outlet from the

roof Hmin

=Z+0.50m

Height of the reflux

zone Z [m]

15 1.85 1.00 0.50

30 1.50 1.30 0.80

45 1.30 2.00 1.50

60 1.20 2.60 2.10

1.3 External air intake vent

-The stove must have the air necessary to ensure smooth combustion operation and good

environmental well-being.

-Make sure that the room where the stove is installed offers sufficient ventilation and install an air

supply duct from the outside with the recommended minimum section of 100 cm².

-The air intake vent must communicate directly with the installation room of the stove, positioned so

as to prevent it from being blocked and protected with a permanent non-lockable grid or other

suitable protection provided that it does not reduce the minimum section.

-Air flow can also be obtained from a room adjacent to the installation room, provided that this flow

can be carried out freely through permanent, non-closable openings communicating with the outside.

-With respect to the installation room, the adjacent room should not be put under vacuum with

respect to the external environment as a result of a reverse draft caused by the presence in this

space of another utility device or suction device. The room adjacent to the permanent openings must

meet the requirements set out in the paragraphs above. The adjacent room cannot be used as a

garage, for storage of combustible material or for activities involving a risk of fire.

1.4 Connection to the chimney flue

(see paragraph 4.5)

1.5 Preventing house fires

Installation and use of the stove must be in accordance with the manufacturer's instructions and with

local habitability regulations.

CAUTION: when a fume exhaust pipe passes through a wall or ceiling, particular installation methods

must be applied (protection, thermal insulation, distances from heat sensitive materials, etc.).

- The fireplace connecting tube must never pass through a combustible surface.

- Do not connect this unit to a chimney flue already being used by another device.

-It is also advisable to maintain all combustible elements or flammable material such as beams,

wooden furniture, curtains, flammable liquids, etc. outside the radiation area of the furnace and at

a distance of at least 1 m from the heating block. .

-In the event that the surrounding space has coverings in combustible or heat-sensitive material, a

protective membrane made of non-combustible insulating material must be interposed. If the flooring

is made of combustible material, a non-combustible protective material that protrudes laterally and

frontally from 15cm to 30 cm must be provided at the mouth of the furnace.

- For further information, refer to local requirements.

2 SPECIFICATIONS AND TECHNICAL DATA

2.1 Specifications

Stoves and pellet stoves are devices built to work with good quality wood pellets only (see par. 3

fuel). Hydro models must be connected to the plumbing system.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eva Calor Hydro 27 kW Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Eva Calor Hydro 27 kW

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info