Bedienungsanleitung EVBox BusinessLine (Seite 13 von 32) (Englisch)

802147

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

6. Install station

6.1 Safety requirements

Connecting and installing this product must be done by a qualied electrician. The owner or

facility manager is responsible for the installation, operation, and maintenance of the charging station,

whereby both the law regarding the safety of persons, animals, and property must be observed, as well

as the installation instructions enforced in the country of use.

Read the safety instructions before you start work on the installation.

Ensure the correct supply voltage/power and ensure that the meter cabinet is properly secured.

• The charging station complies with Safety Class I (the charging station is supplied with a ground

terminal for safety) and overvoltage Category III. The charging station complies with Safety Class I

(ground terminal safety) and Category III (overvoltage).

• The incoming and/or outgoing terminals for the alternating current are tted with an

uninterruptible grounding for safety. If it is possible that the ground safety has been damaged, the

charging station must be taken out of operation and secured against accidental activation.

• Each charging station must be protected by a residual current device (Type A-EV or Type B)

with direct current fault detection of >6 mA DC. The residual current device must disconnect

all the phases connected and the “Neutral”. The applied RCD must comply with local law and

regulations.

• Before switching on the charging station, check that the power source available corresponds

to the conguration settings of the charging station as described in this manual and that all the

cables inside the charging station have been properly connected.

• Make sure that the product is only used under the correct operating conditions (refer to chapter

“4. Technical specications”).

• Never operate the charging station in wet or very dusty surroundings.

Planning the installation

Minimum requirements

• Make sure that each side of the unit is connected to its own dedicated power line, except for

models BXXX2-X20XX (which must be powered by a 1 x 32A rated power cable).

• Calculate the existing electrical load to nd the maximum operating current.

• Calculate the distance to ensure minimal voltage drop.

• Obtain any necessary permits from the local authority that has jurisdiction and make sure to

schedule the follow-up inspection with a qualied and licensed electrician after the installation is

complete.

• Use only copper conductors.

• Refer to local wiring regulations to select the conductor sizes.

• Ensure that there is always adequate free space (at least 20 cm) around the charging station for

ventilation purposes.

• Use appropriate tools and provide resources and protection measures.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

EVBox BusinessLine Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von EVBox BusinessLine

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info