Bedienungsanleitung Eve Motion Blinds - Roller Blinds (Seite 8 von 26) (Englisch)

817984

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

Important Safety instructions

WARNING: To reduce the risk of severe injury or

death, it is important to follow these instructions

for personal safety. Save these instructions.

Read and follow all installation instructions.

This appliance can be used by children aged

8 years and above and persons with reduced

physical, sensory or mental capabilities or lack

of experience and knowledge if they have been

given supervision or instruction concerning use

of the appliance in a safe way and understand

the hazards involved. Children should not

play with the appliance. Cleaning and user

maintenance should not be performed by

children without supervision.

Do not allow children to play with fixed controls.

Keep remote controls away from children.

Frequently examine the installation for

imbalance and signs of wear or damage to

cables and springs. Do not use if repair or

adjustment is necessary.

This instruction manual is also available on the

website.

The drive must be disconnected from its power

source during cleaning, maintenance and when

replacing parts.

The A-weighted emission sound pressure level

of the drive is equal to or less than 70dB(A).

Indoor and household use only.

Disconnect the drive from the power supply

or switch off the automatic controls when

maintenance, such as window cleaning, is

being carried out in the vicinity.

When operating a biased switch, make sure that

other persons are kept away.

Do not operate when maintenance, such as

window cleaning, is being carried out in the

vicinity.

The tube motor must only be supplied with safety

extra low voltage corresponding to the marking

on the appliance.

Important Installation instructions

WARNING: Important safety instructions. Follow all

instructions, since incorrect installation can lead

to severe injury.

This motor can only be used with soft material

for driven parts.

Hazardous unprotected moving parts of the

drive must be installed higher than 2.5m above

the floor or any other level surface that could

provide access to it.

Install the actuating member of a manual

release at a height less than 1.8m.

The actuating member of a biased switch is to

be located within direct sight of the driven part

but away from moving parts. It is to be installed

at a minimum height of 1.5m and not accessible

to the public.

The mass and the dimension of the driven part

must be compatible with the rated torque and

rated operating time.

Fixed controls have to be clearly visible after

installation.

The driven part must be compatible with the

rated torque 1.1 N.m and rated operating time

(12 min).

Minimum tube diameter: Ø25mm.

The drive is intended to be installed at a height

of at least 2.5m above the floor or any other

accessible level surface.

All-pole disconnection switches must be

incorporated in the fixed wiring in accordance

with the wiring rules.

The appliance must only be supplied at safety

extra low voltage corresponding to the marking

on the appliance.

Before installing the drive, remove any

unnecessary cords or components and disable

any equipment not needed for powered

operation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Eve Motion Blinds - Roller Blinds Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info