Bedienungsanleitung EWT CDW15WO (Seite 4 von 24) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

460331

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

- 1 -

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

General

Unpack the heater carefully and retain the packaging for possible future use, in the

event of moving or returning the fire to your supplier.

The fire incorporates a flame effect, which can be used with or without heating, so that

the comforting effect may be enjoyed at any time of the year. Using the flame effect on

its own only requires little electricity.

These models are designed to be free standing and are normally positioned against a

wall.

Before connecting the heater check that the supply voltage is the same as that stated

on the heater.

Please note: Used in an environment where background noise is very low, it may

be possible to hear a sound which is related to the operation of the flame effect.

This is normal and should not be a cause for concern.

Electrical connection

WARNING – THIS APPLIANCE MUST BE EARTHED

This heater must be used on an AC ~ supply only and the voltage marked on the

heater must correspond to the supply voltage.

Before switching on, please read the safety warnings and operating instructions.

Controls - see Fig. 2

Switch 1 Controls the electricity supply to the heater and flame effect. Note: This

switch must be in the ON position for heater to operate with or without

heat.

Switch 2 Turns the heat ON/OFF.

Thermostat (T) - see Fig. 2

In order to maintain a certain room temperature, set the controller to ‘max.’. Operate

the appliance at full power until the required room temperature is reached. Set back

the thermostatic controller until the appliance switches off with an audible “click”. This

temperature will be kept almost constant by the thermostatic control switching on and

off automatically. Please note that the appliance can only be switched on when the

thermostat setting is higher than the room temperature.

Thermal Safety Cut-out

A thermal safety cut-out is incorporated in the heater to prevent damage due to

overheating. This can happen if the heat outlet was restricted in any way. The heater

will switch on once the obstruction has been removed and the heater has cooled. If the

cut-out continues to operate intermittently, the heater should be switched off and a

service agent contacted.

Maintenance

WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE

ATTEMPTING ANY MAINTENANCE.

Lamp Replacement - see Fig. 3, Fig. 4 and Fig. 5

The lamps are located behind the back panel. To gain access to the lamps, the screws

indicated in Fig. 3 which secure the back panel, must be removed.

Remove and slide out panel as indicated on Fig. 4.

Remove the defective lamp by unscrewing it as shown in Fig .5.

Replace with a 60W E14 SES Clear candle lamp. Take care not to over-tighten the

lamp.

Refit the back panel and secure with the screws.

Recycling

For electrical products sold within the European Community.

At the end of the electrical product's useful life it should not be disposed of with

household waste. Please recycle where facilities exist. Check with your Local

Authority or retailer for recycling advice in your country.

Cleaning

WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE

CLEANING THE HEATER.

For general cleaning use a soft clean duster – never use abrasive cleaners. The glass

viewing screen should be cleaned carefully with a soft cloth. DO NOT use proprietary

glass cleaners.

To remove any accumulation of dust or fluff the soft brush attachment of a vacuum

cleaner should occasionally be used to clean the outlet grille of the fan heater.

After Sales Service

Should you require after sales service or should you need to purchase any spares,

please contact the retailer from whom the appliance was purchased or contact the

service number relevant to your country on the warranty card. Please do not return a

faulty product to us in the first instance as this may result in loss or damage and delay

in providing you with a satisfactory service. Please retain your receipt as proof of

purchase.

Important Safety Advice:

When using electrical appliances, basic precautions should always be

followed to reduce the risk of fire, electrical shock and injury to persons,

including the following:

If the appliance is damaged, check with the supplier before installation and

operation.

Do not use outdoors.

Do not use in the immediate surroundings of a bath, shower or swimming

pool.

Do not locate the heater immediately below a fixed socket outlet or

connection box.

This appliance is not intended for use by children or other persons without

assistance or supervision if their physical, sensory or mental capabilities

prevent them from using it safely. Children should be supervised to ensure

that they do not play with the appliance.

Do not use this heater in series with a thermal control, a program controller,

a timer or any other device that switches on the heat automatically, since a

fire risk exists when the heater is accidentally covered or displaced.

Ensure that furniture, curtains or other combustible material are positioned

no closer than 1 metre from the heater.

In the event of a fault unplug the heater.

Unplug the heater when not required for long periods.

Although this heater complies with safety standards, we do not recommend

its use on deep pile carpets or on long hair type of rugs.

The appliance must be positioned so that the plug is accessible.

If the supply cord is damaged it must be replaced by the manufacturer or

service agent or a similarly qualified person in order to avoid a hazard.

Keep the supply cord away from the front of the heater.

WARNING: In order to avoid overheating, do not cover the heater. Do

not place material or garments on the heater, or obstruct the air

circulation around the heater. The heater carries the Warning symbol

indicating that it must not be covered.

EWT CDW15WO Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info