514933
9
Zoom out
Zoom in
Vorherige Seite
1/17
Nächste Seite
~ 8 ~
© 2013 VAN OS MEDICAL B.V., Koperslagerij 3, 4651 SK, Steenbergen, The Netherlands
Tel. +31-(0)167-573020, Fax +31-(0)167-573381, E-mail: info@vanosmedical.nl, www.vanosmedical.com
6.3.1 Diagnosing Faults
Use the following troubleshooting guide if the scooter fails to operate.
Note:
Turn the key switch on before beginning any diagnostics.
If the Status Light is OFF
Check that the key switch is turned ON
Check that all cables are connected correctly
If only the leftmost diode of the battery charge display is PERMANENTLY ON
Contact your authorized Excel® Dealer
If the leftmost diode of the battery charge display is FLASHING
Count the number of flashes and refer to the next section.
6.3.2 Flash Codes
Number
of
flashes
Fault
Impact on Scooter
Notes
1
Battery needs
charging
Will Drive
Battery charge is running low. Recharge the batteries as soon
as possible.
2
Battery voltage
too low
Drive inhibited
Battery charge is empty. Recharge the batteries.
If the scooter is left off for a few minutes, battery charge may
recover sufficiently to allow driving for a short period of time.
Lifter raised
Driving speed
reduced
Lower lifter completely.
3
Battery voltage
too high
Drive inhibited
Battery charge is too high. If a charger is plugged in, unplug it.
The electronic system charges the batteries when travelling
down slopes or decelerating. Excessive charging in this manner
may cause this fault. Turn the scooter power off and then back
on again.
4
Current Limit
Time Out
Drive inhibited
The scooter has drawn too much current for too long, possibly
because the motor has been over-worked, jammed or stalled.
Turn the scooter power off, leave it off for a few minutes, and
then turn the power back on again.
The controller has detected a short-circuited motor. Check the
cable harness for short and check the motor: Contact your
authorised Excel® Dealer. Check that the declutching lever is
in the engaged position.
5
Brake Fault
Drive inhibited
The park brake coil or wiring is faulty. Check the park brake
and wiring for open or short circuits. Contact your authorised
Excel® Dealer.
6
Out Of Neutral
Drive At Power
Up
Drive inhibited
Throttle is not in neutral position when turning key switch on.
Return throttle to neutral, turn power off, and back on
again.
Throttle may need to be re-calibrated. Contact your authorised
Excel® Dealer.
7
Speed Pot Error
Drive inhibited
The throttle or its wiring may be faulty or incorrectly set up.
Contact your authorized Excel® Dealer.
8
Motor Volts
Error
Drive inhibited
The motor or its wiring is faulty. Contact your authorised
Excel® Dealer.
9
Other Internal
Errors
Drive inhibited
Contact your authorized Excel® Dealer.
9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Excel Entice 4 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Excel Entice 4

Excel Entice 4 Bedienungsanleitung - Holländisch - 25 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info