Bedienungsanleitung Expobar Markus (Seite 20 von 49) (Deutsch, Englisch, Französisch, Spanisch)

499724

Zoom out

Zoom in

Vorherige Seite

1/49

Nächste Seite

• Cleaning of the espresso machine

English 18

Lever

• Pull from the ground coffee dosage device lever (9) towards you in order to obtain a dosage and

release the coffee dosage device lever free.

• Place the porta filter under the coffee tamper (9) and push it upwards in order to compact the coffee.

18.3. Adjusting the grinding degree of coffee

You can adjust the grinding degrees (thinner ground coffee/coarser ground coffee) as follows:

• If you want to obtain thinner grinded coffee: Maintain pressed the millstone trigger (5)(models till

2009) while turning right the setting grind wheel (4), then release the trigger.

• If you want to obtain a coarser grinded coffee:. Maintain pressed the millstone trigger (5) (models

till 2009) while turning left the setting grind wheel (4), then release the trigger.

18.4. Adjusting of the grinded coffee quantity per dosis

• Switch OFF the grinder general switch, (8).

• Remove ground coffee dosage device lid (6).

• In order to get lower dosage: Turn the coffee grinding adjustment disk

clockwise.

• In order to get higher dosage: Turn the coffee grinding adjustment disk

counter clockwise.

• Re-install the ground coffee dosage device lid (6) in place.

Note; as to measure 7 grs of grinded coffee you get a measuring spoon with the

machine.

• If when brewing espresso, it comes out very fast, the grinder is set too

coarse.

If when brewing espresso, it comes out very slow, the grinder is set too thin.

Espresso should come out with a slow, thin and continuous flow.

19. Cleaning of the espresso machine

Remember, as to get the best performance from the machine, descale and cleaning are to be observed.

Disconnect the machine from the main supply prior to cleaning the machine. All the body exterior can be

cleaned with a damp cloth. Do not use abrasive or dissolvent products.

19.1. Cleaning of group

• Unlock & remove the porta filter from the group head.

• Place the blind filter membrane on the filter basket.

• Insert a sachet of detergent into the porta filter. You must use specific detergents for this kind of

cleaning, suitable for the cleaning of the group of espresso machines.

• Lock the porta filter into the group head.

• If you have a Pulser machine (no keypad) press the brew switch for 10 seconds, then release for 3

seconds; and then repeat again this action for at least five times more.

• If the machine is of the type Control, (it has keypad), activate the auto-cleaning cycle as follows:

Switch off the machine, then keep pressed the button “2 short coffees” and turn on the machine. Now you

can release the button; the auto-cleaning will automatically repeat a cleaning cycle.

Important: Once finished the cleaning process, remove the porta filter and run water through the group again

to rinse out all remains. Repeat the cleaning process without detergent once more for a perfect result.

“DO NOT MANIPULATE THE PORTA FILTER DURING THE AUTO - CLEANING PROCESS”.

• Cleaning the groups everyday with the filter membrane but without detergent is recommended.

• Cleaning the groups with the filter membrane and detergent is recommended once a week.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Expobar Markus Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info