Seite | 29
• Do not suck up burning or
glowing items such as
cigarettes or seemingly
extinguished ash.
• Do not suck up liquids or
damp dirt. Let damp cleaned
or shampooed carpets dry
before vacuuming.
• Do not suck up toner dust
from printers or copiers. The
filter system cannot filter
toner dust perfectly. The toner
dust would be blown into the
room again by the blower.
• Do not vacuum up easily
flammable or explosive
materials or gases.
• Do not vacuum up sharp-
edged, heavy or hard objects.
The vacuum cleaner would be
blocked.
• Do not stand or sit on the
vacuum cleaner.
13 Assembly of the wall
bracket
WARNING!
Make sure beforehand whether
there are lines hidden in the
wall that you could damage!
8 Measure the height for the
wall bracket.
9 Hold the vacuum cleaner
against the wall, when it is
completely assembled with
both suction tubes and the
floor nozzle.
10 Hold the wall bracket
against the wall so that the
two boreholes are above it.
11 Mark holes.
12 Bore the holes and set the
dowels in the wall.
13 Stick the screws through
the boreholes of the wall
bracket. Turn the screws
with the wall bracket into
the dowels.
14 Hand tighten the screws.
14 Initial start-up and
operation
• Put a suction tube with the
thicker end on the
connection on the
appliance.
• If necessary put the thicker
end of the second suction
tube on the other suction
tube.
• In order to loosen the
suction tubes, twist them
slightly to pull them off.
14.1 Using the appliance
8 Unwind the mains cable
completely.
9 Insert the mains plug into
an earthed socket that has
been installed in
accordance with the
regulations.
10 Turn the appliance on with
the On/Off switch.
11 Switch position: 1
12 Adjust the floor nozzle with
the lever in accordance
with the floor covering.
13 Now use the vacuum
cleaner with an even
speed.
14 Pressing on it isn’t
necessary.
