Bedienungsanleitung Exquisit GTE 350 (Seite 16 von 37) (Deutsch, Englisch, Holländisch, Französisch)

564679

Zoom out

Zoom in

Vorherige Seite

1/37

Nächste Seite

English Instruction for use CHEST FREEZERS

15 Resolving faults on your own

Danger warning

Never use electrical appliances to defrost the chest

freezer, e.g. hair dryer, fan heater, or devices with a naked

flame (e.g. candles).

Plastic in the inner compartment can melt and escaping

gas can be ignited by sparks or naked flames.

Proceed as follows:

1. Provide a suitable non-metallic container (plastic

container or wash-basket).

2. Make absolutely sure that you remove the plug

from the power socket.

3. Dry your hands thoroughly to prevent skin damage by

contact with ice (it is advisable to use gloves).

4. Remove all frozen food from the freezer, roll it firmly

in newspaper, put it into the container, place the

container in a cool, dry room.

5. Cover up the container all around with a thick blanket.

6. Lift the separator (e) (not all models are equipped)

upwards out of the guide-rail of the freezer.

7. Use the divider (so far as provided) as a defrosting

dish and push it on the side under the freezer – where

the defrosting water drain-plug is located.

8. Pull the plug (as far as provided) out of the freezer

bottom.

9. As previously described, scrape the thickest ice

carefully from the freezer inside and put it into the

kitchen sink. for defrosting.

10. If necessary, speed up defrosting by placing a large

pot of warm (not too hot) water on the freezer bottom.

11. In freezers not provided with a drain-plug, continuously

wipe up the water with a sponge.

12. Thoroughly clean the inside. Rinse it with a mixture of

warm water and vinegar, thereafter rinse with clear

water.

13. Wipe the freezer with an absorbent cloth thoroughly

dry and allow to air for about 3 to 4 minutes.

14. Replace the drain-plug (if provided)

15. Empty the dry defrosting water dish (if provided) and

slide it as separator into the guide rails of the freezer.

16. Close the chest and plug it back into the socket.

17. Set the temperature control (l) to maximum setting

(green and red lamps go on) and switch on the FAST

FREEZE SWITCH (FIG.4) (if provided) (the yellow

lamp lights additionally).

18. Now refill the frozen food – the oldest items at the top.

To prevent frosted food from defrosting, carry out

steps from 1 to 17 within max. two hours.

19. When the red lamp goes off, reset the temperature

control to a as per the filling capacity suitable storage

temperature.

20. Switch off the FAST FREEZER SWITCH (if provided)

after about 8 to 12 hours or, latest after 24 hours (the

yellow light goes off).

14 Interior light

(not provided in all models)

A switch is built into appliances equipped with lighting.

When the appliance is opened the light goes on

automatically and switches off automatical y when

closed.

The lamp is protected with a transparent cover.

Strictly use 15 W max. replacement bulbs.

High quality manufacturing processes and use of latest

cooling and freezing technology will principally ensure

trouble-free function of your appliance.

If you suspect any fault, before contacting the after-sales

service directly or via your dealer, make sure you have

observed all instructions and advice in this user manual.

Repairs by the after-sales service, of faults that have

occurred because of non-adherence to the information and

advice given in this manual have to be charged to the

customer and are not covered by your dealer’s guarantee.

Attention

The compressor (also known as motor) must not operate

continuously.

It is controlled by the thermostat which you set with the

temperature control (FIG.4). It switches on automatically

when the set temperature in the storage compartment

exceeds and switches off automatical y when the correct

temperature is reached again.

Noise can be heard in every compressor – cooling system

when the compressor is switched on. This noise is

produced when the motor in the compressor operates and

also by refrigerant flowing in the cooling system circuit.

These noises are normal and do not indicate any functional

trouble.

In unheated rooms and in cold weather condition

condensation can build up on the outer walls of the

appliance. This does not mean trouble and disappears

when the weather becomes warmer.

NOTE

Water condensation on the bottom side of the appliance

could happen if there is poor ventilation in a wet

environment. It's not a fault of the product and it could be

fixed by turning the adjustable feet of the product to the

higher maximum position in order to increase the space

between the bottom surface and the floor.

16 After-sales service

Call the after-sales service only, if after analysis of possible

trouble/fault factors you cannot find any cause for the

defect or do not have the means to eliminate the trouble.

Therefore first check under “What is when ....”

Consult the enclosed guarantee card or the separately

enclosed after-sales centres list, to see which company is

responsible for servicing your appliance. If several after-

sales centres are mentioned on the list, select the nearest

one to you.

If no after-sales service centres list is enclosed with your

appliance, contact your dealer.

In order to receive immediate help, make sure you have

ready the following essential data to identify your

appliance:

• Brand of appliance

• Model / Type

• Kind of trouble

• Date of purchase

• Purchased from whom?

Exquisit GTE 350 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info