Bedienungsanleitung Extraflame INSERTO COMFORT P85 PLUS (Seite 27 von 40) (Englisch)

695965

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

27ENGLISH

IGNITION

Once the previously listed points have been checked, press key

for three seconds to ignite the stove. During ignition, the stove will check

for a ame for a period of 15 minutes. Once the control temperature has been reached, the

stove interrupts the ignition phase and switches to PREPARATION.

PREPARATION

During the preparation phase, the stove stabilises combustion, increasing it progressively, to then start ventilation and switch to WORK

WORK

In the work phase, the stove operates at the POWER dened by the user, heating the room until SET THERMOSTAT is achieved. See next

heading.

ADJUSTING SET THERMOSTAT

The ambient SET THERMOSTAT can be set using keys 2 and 3, from LOWTA 7 - 37 °C - HOT. If the value is between 7 - 37 °C, the stove checks

the ambient temperature by means of the radio control probe. Once the set temperature has been reached, the stove automatically reduces

the power, guaranteeing best comfort and reducing pellet consumption: this process is called “modulation”.

LOWTA  HOT

If the SET THERMOSTAT is “LOWTA” (set under the 7° threshold), temperature checking is entrusted to the additional thermostat contact,

thus bypassing the radio control temperature probe.

If the contact is open (fullled), the stove works at minimum power.

If the contact is closed (request), the stove works at the set power.

If the setting is on “HOT” (set above 37°C), the stove only works at the set power, thus bypassing the external contact and the temperature

probe.

ADJUSTING SET POWER

The power has 5 operating levels, when key

is pressed, the set power is displayed; it can be changed using keys

Power 1 = minimum level - Power 5 = maximum level.

The change must be conrmed by pressing the key

AUTO BLOW

During the work phase, the stove cleans the burn pot at regular intervals with an "AUTO BLOW".

When this procedure starts, a message is displayed. During the "AUTO BLOW" procedure, the pellet feed slow down and the fumes motor

increases.

After cleaning, the stove resumes operation in normal conditions.

SWITCHOFF

Press the key

for three seconds.

Once this operation has been performed, the appliance automatically enters the switch-o phase, blocking the supply of pellets.

The ue gas exhaust motor and the hot air ow motor will remain on until the stove temperature has dropped below the safety settings.

REIGNITION

The stove can only be re-ignited if the temperature of the exhaust fumes is lower than the preset threshold and the minimum safety time has

passed.

OPERATION AND LOGIC

NO IGNITION

THE APPLIANCE MAY FAIL TO LIGHT BECAUSE THE AUGER IS EMPTY AND NOT ALWAYS ABLE TO LOAD THE BURN POT

FAST ENOUGH WITH THE PELLETS NEEDED FOR NORMAL IGNITION.

IF THE PROBLEM OCCURS AFTER ONLY A FEW MONTHS OF OPERATION, CHECK THAT THE ROUTINE CLEANING

DESCRIBED IN THE STOVE HANDBOOK HAS BEEN CARRIED OUT CORRECTLY

DO NOT USE ANY TYPE OF FLAMMABLE LIQUIDS FOR IGNITION!

DO NOT ALLOW THE BAG OF PELLETS TO COME INTO CONTACT WITH THE BOILING HOT STOVE DURING THE

FILLING PHASE!

IN THE EVENT OF CONTINUED FAILURE TO LIGHT, CONTACT AN AUTHORISED TECHNICIAN.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Extraflame INSERTO COMFORT P85 PLUS Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Extraflame INSERTO COMFORT P85 PLUS

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info