Bedienungsanleitung Extraflame LP20 (Seite 6 von 40) (Englisch)

811772

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

INTRODUCTION

The boilers produced in our establishment are built with attention to the individual components so as to protect both the user

and the installer from any accidents. It is therefore recommended that after any intervention on the product, that authorised

sta pay particular attention to the electric connections, especially the stripped parts of the wires. These must not escape from

the terminal board in any situation, thus preventing possible contact with the live parts of the wire.

The instruction manual is an integral part of the product: make sure that it always accompanies the appliance, even if transferred

to other owners or user or is transferred to another place. If it is damaged or lost,request another copy from the area technician.

This boiler must be intended for the use it has been specically made for. The manufacturer is exempt from any liability,

contractual and extracontractual, for injury/damage caused to persons/animals and objects, due to installation, adjustment

and maintenance errors and improper use.

INSTALLATION

Installation of the boiler and auxiliary equipment in relation to the heating system must comply with all current Standards and

Regulations and to those envisioned by the law. Installation must be carried out by authorised sta, who must provide the buyer

with a declaration of conformity for the system and will assume full responsibility for nal installation and as a consequence the

correct functioning of the installed product.

It is necessary to bear in mind all laws and national, regional, provincial and town council Standards present in the country the

appliance has been installed.

Extraame S.p.A. cannot be held responsible for the failure to comply with such precautions. It is recommended to wash all

the pipes of the system well before installation to remove any residue that could compromise the correct operation of the

appliance. During installation, inform the user regarding:

a. If water leaks, he must close the water supply and promptly inform the after-sales technical service.

b. The system working pressure must be checked periodically. If the boiler is not used for a long period of time, it is recommended

to contact the after-sales technical service to carry out at least the following operations:

- Set the master switch to position 0.

- Close the water taps of both the heating system and the domestic hot water system.

- Empty the heating system and the domestic hot water system if there is risk of freezing.

COMMISSIONING

After removing the packaging, ensure that the content is intact and complete.

Otherwise, contact the dealer where the appliance was purchased from.

When commissioning the product, verify that all safety and control devices that the boiler consists of work well. All electrical

components that make up the boiler must be replaced with original spare parts exclusively by an authorised technical assistance

centre, thereby guaranteeing correct operation.

Before leaving the system, the sta in charge of commissioning must monitor boiler operation for at least one complete work

cycle. The boiler must be serviced at least once a year, programming it in advance with the technical assistance centre.

APPROVALS

The Extraame boilers have been designed and realised in compliance with the following Directives:

UNI EN 303-5 Boilers for central heating. Boilers for solid fuel, with manual and automatic feeding, with a nominal heat

output of up to 300 kW

Compliance with the Low Voltage Directive (73/23 EEC)

Compliance with the EMC Directive (Electromagnetic compatibility 89/336 EEC)

FOR SAFETY

It is forbidden for the boiler to be used by children or unassisted disabled persons.

Do not touch the boiler when you are barefoot or when parts of the body are wet or humid.

The safety and adjustment devices must not be modied without the authorisation or indications of the manufacturer.

Do not pull, disconnect, twist electric cables leaving the boiler, even if disconnected from the electric power supply mains.

Do not close or reduce the dimensions of the airing vents in the place of installation.

The airing vents are indispensable for correct combustion.

Do not leave the packaging elements within reach of children or unassisted disabled persons.

The hearth door must always be closed during normal functioning of the product.

Avoid direct contact with parts of the appliance that tend to heat up during functioning.

Check for the presence of any obstructions before switching the appliance on following a prolonged standstill period.

| ENGLISH

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Extraflame LP20 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Extraflame LP20

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info