Bedienungsanleitung Extraflame Lucia (Seite 19 von 36) (Englisch)

695853

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

19ENGLISH

OPERATION AND LOGIC

NEVER USE FLAMMABLE LIQUIDS FOR IGNITION!

WHILE FILLING, DO NOT BRING THE PELLET BAG IN CONTACT WITH THE BOILING STOVE!

IN CASE OF CONTINUOUS FAILED IGNITIONS, CONTACT AN AUTHORISED TECHNICIAN.

DO NOT USE THE APPLIANCE WITHOUT THE SEPARATOR AND/OR FLAME

GUARD SEE FIGURE TO THE SIDE. REMOVING THEM WILL AFFECT THE SAFETY

OF THE PRODUCT AND WILL INVALIDATE THE WARRANTY IMMEDIATELY. IN

THE EVENT OF WEAR OR DETERIORATION, REQUEST THE REPLACEMENT OF

THE PART FROM THE SERVICE CENTRE THIS TYPE OF REPLACEMENT IS NOT

COVERED BY WARRANTY BECAUSE IT IS A COMPONENT SUBJECT TO WEAR.

SEPARATOR

IGNITION

After checking the previous points, press the 1 for three seconds to switch on the stove. For the ignition phase, 15 minutes are available during

which the presence of the ame is checked. When the control temperature has been reached, the stove stops the ignition phase and goes into

PREPARATION.

PREPARATION

During the preparation phase, the stove stabilises and gradually increases combustion, and then activates the ventilation and goes into WORK

WORK

During the work phase, the stove reaches the Set Power dened by the user, heating the room until the Set Thermostat has been reached. See

following note.

SET THERMOSTAT

The Set room thermostat can be set using keys 4 and 5, from LOWTA - 7°C - 37°C - HOT. If the value is between 7°C - 37°C, the stove checks

the room temperature using a probe on the machine. Once the set temperature has been reached, the stove automatically reduces the power

ensuring optimal comfort and reducing the consumption of pellets: this process is called "modulation".

LOWTA / HOT

If the Set Thermostat is "LOWTA" (set below the 7° threshold) the temperature is checked by the additional thermostat contact, thus ignoring

the temperature probe on the machine.

If the contact is open (met), the stove operates at the minimum value.

If the contact is closed (required), the stove operates at the set power.

If the setting is on “HOT” (set above 37°C) the stove always operates at the set power, ignoring the external contact and the temperature probe.

SET POWER

The Set Power ha 5 levels of operation. The power can be changed using keys 2 or 3.

Power 1 = minimum level - Power 5 = maximum level.

The change is saved after exiting by pressing 1.

BLOW

During the work phase and at regular time intervals, the stove cleans the burn pot by means of an operation called "BLOW".

The activation of this function is shown on the display with the relative message. During the "BLOW" the pellet loading is slowed down and

the fumes motor is increased.

After the cleaning phase, the stove goes back to the normal operating conditions.

SWITCHOFF

Press 1 for three seconds.

After performing this operation, the appliance automatically enters the switch-o phase, and stops loading pellets.

The fumes motor and the hot air fan motor remain on until the stove temperature falls below the safety threshold.

REIGNITION

The stove can be switched back on only if the fume temperature is lower than a preset threshold and if a minimum safety time has elapsed.

FLAME GUARD

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Extraflame Lucia Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Extraflame Lucia

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info