Bedienungsanleitung Extraflame Mirka Plus (Seite 23 von 40) (Englisch)

811685

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

23ENGLISH

EASY SETUP

The volumetric weight of the pellet is the ratio between the weight and the volume of the pellet. This ratio may change without altering

pellet quality. By using the EASY SETUP function, it is possible to dose the pellets by increasing or decreasing the preset values.

In the stove program, the available values range from “– 3” to “+ 3”; all stoves are calibrated during production with the optimal value which

is 0

If you notice an excessive deposit on the burn pot, access the EASY SETUP program and lower the value by one unit to “- 1”; then wait until

the next day and if there is no improvement, decrease again, to a maximum of “- 3”. If, on the other hand, it is necessary to increase the pellet

dosage, switch the factory value from "0" to "+ 1, + 2, + 3" as required.

CONTROLS PROCEDURE

Press key 6.

Press key 3 until EASY SETUP appears and conrm by pressing key 6.

Use keys 4 -5 to set the range.

Press key 6 to conrm and key 1 to scroll back through the menus until the initial page.

EXCESSIVE PELLET DEPOSIT IN BURN POT NORMAL OPERATION MINIMUM PELLET DEPOSIT IN BURN POT

-3 -2 -1 0 +1 +2 +3

THIRD DECREASE

RANGE IF THE

FIRST TWO ARE

INSUFFICIENT

SECOND

DECREASE

RANGE IF

THE FIRST IS

INSUFFICIENT

FIRST DECREASE

RANGE (TEST FOR

1 DAY )

OPTIMAL FACTORY

VALUE

FIRST INCREASE

RANGE

SECOND

INCREASE RANGE

IF THE FIRST IS

INSUFFICIENT

THIRD INCREASE

RANGE IF THE

FIRST TWO ARE

INSUFFICIENT

N.B.: IF THESE ADJUSTMENTS DO NOT SOLVE THE PROBLEM OF PELLET DEPOSITS IN THE BURN POT, PLEASE CONTACT YOUR LOCAL

SERVICE CENTRE.

AIR ZONE CONTROL MIRKA PLUS

This menu allows you to enable the AIR ZONE CONTROL mode

Range: (ON, OFF)

If ON is selected, the stove will optimise the adjustments so that the heat is sent to the ducting when the main room temperature set is

reached.

CONTROLS PROCEDURE

Press key 6.

Press 3 until AIR ZONE CONTROL appears and conrm by pressing 6.

Use keys 4--5 to enable (ON) or disable (OFF)

Press key 6 to conrm and key 1 to scroll back through the menus until the initial page.

When the function is active, AIR ZONE CONTROL appears on the display

WARNINGS: If the appliance is installed with air ducting active, but ambient probe or thermostat for air ducting (i.e. the jumper is

kept on the ducting terminal), and the AIR ZONE CONTROL function is activated, it sends heat into the ducting regardless of the

temperature of the room receiving the ducting.

CHRONO

This function allows stove ignition and switch-o to be automatically programmed.

The factory setting for CHRONO is o.

The chrono allows the programming of 4 time slots per day, which can be used every day of the week.

In each time slot, it is possible to set

the ignition and switch-o times, the days of use of the programmed time slot, the desired temperature (if SET TEMPERATURE) is

used and the set power. Current day and time settings are essential for the correct operation of the Chrono.

Recommendations

Before using the chrono function, you must set the current date and time, so check that you have followed the points listed in the sub-

chapter “DATETIME”. To use the chrono function correctly, it must not only be programmed, but also enabled. The 4 time slots can be

overlapped using the ignition and switch-o time settings. In this way, it is possible to create a combination of time slots with dierent

temperatures and power levels, without changing the status of the stove.

N.B.: in the case of overlapping time slots, the stove will remain on until the last switch-o time.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Extraflame Mirka Plus Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Extraflame Mirka Plus

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info