Bedienungsanleitung Extraflame Moira SP (Seite 25 von 36) (Englisch)

696238

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

ENGLISH

DELAYED SWITCHOFF

The appliance can be programmed for delayed switch-o. For example, if it is 8.00pm and delayed switch-o is set to 1 hour, at 9.00pm the

stove will automatically switch o.

When keys 6 + 2 are pressed and held, the “DELAYED SWITCHOFF” screen opens up (this setting can only be congured when the machine

is in preparation or work mode.

Using keys 2 and 3, it is possible to increase/decrease the number of hours after which the stove will enter the nal cleaning phase on its

own. The possible hours range between OFF, and 1 to 9.

When P6 is pressed, the setting is conrmed and the user returns to the home screen.

1 hour before the set switch-o time, the remaining work time is indicated and the message “switch-o in” and value “HOURS xx:xx” is

displayed.

DELTA T

This function allows the hysteresis limit to be set for stove switch-on and switch-o DELTA T, used as

an interval of regulation in the event the room temperature is not managed by an external thermostat.

The exact switch-on temperature is SET THERMOSTAT  DELTA T. The switch-o temperature is SET

THERMOSTAT + DELTAT.

Possible DELTAT values range from: 0.5 - 5°C.

To set: OK > SETTINGS > DELTAT

RESET

Allows the user to restore all editable values to the default values.

To set: OK > SETTINGS > RESET.

INSTALLATION MUST BE PERFORMED BY QUALIFIED STAFF AND/OR THE MANUFACTURER'S AFTERSALES

TECHNICIANS.

ADDITIONAL FUNCTIONS

FIRST LOAD

This function enables the pellet loading gear motor for continuous functioning.

Before enabling this function, make sure the stove is cold and in “OFF” mode. Press buttons 6 + 4 at

the same time for a few seconds until "FIRST LOAD” appears on the screen.

To interrupt continuous loading, simply hold key 6 down for 2 seconds.

INSTALLATION OF SUPPLEMENTARY THERMOSTAT OPTIONAL

The appliance is able to control the room temperature through a supplementary thermostat (optional).

After the stove is switched on (by pressing 1 or in chrono mode), it will work to reach the set thermostat temperature, displaying WORK

(open contact) on the screen. The room sensor supplied standard will automatically be ignored.

When the thermostat reaches the temperature (closed contact) the stove will work at the minimum power level, displaying MODULATION

ON THE SCREEN.

CONTROLS PROCEDURE

 A mechanical or digital thermostat is needed with a “normally open” input type.

 Remove the plug from the socket.

 Using the image to the side as a guide, connect the two thermostat wires (clean contact - no

230 V!) to the respective terminals at the back of the machine, one red and the other black.

 Connect the power to the stove again.

 Press key 3 until SET THERMOSTAT is set to LOWTA.

DEPRESSURE NOTICE

It allows to activate the warning buzzer if the door or hopper is open.

Please note: activating this buzzer may reduce battery life by 30%.

Battery life depends on use.

To set: OK>SETTINGS>DEPRESSURE NOTICE

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Extraflame Moira SP Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Extraflame Moira SP

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info