752950
14
Zoom out
Zoom in
Vorherige Seite
1/36
Nächste Seite
14
USE AND CARE INFORMATION
For Best Results
Starttherangehoodseveralminutesbeforecookingtodevelopproperairow.Allowtherangehoodto
operate for several minutes after cooking is complete to clear all smoke and odors from the kitchen.
Button Function Display
ATurns the suction motor on and off at speed one. Displays the set speed
BDecreases the working speed. Displays the set speed
CIncreases the working speed. Displays the set speed
DActivate intensive speed from any other speed,
including motor off. This speed is set to operate for
6 minutes, after which the system returns to the
speedthatwassetbefore.Suitabletodealwith
maximum levels of cooking fumes.
Displays HI and the time remaining once very
second.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Activated Charcoal Filter alarm
On and Off.
FC+Punto(2ashes)–AlarmOn.
FC+Punto(1ash)–AlarmOff.
E
24H function
Turns the suction motor on at speed one and effects
one 10 minute extraction every hour.
Displays24andthespotatthebottomrightashes
once every second, while the motor is running.
It is disabled by pressing the button.
Whentheltersalarmistriggered,thealarmcan
be reset by pressing and holding this button for
approximately 3 seconds.
These indications are only visible when the motor
is turned off.
FFashesthreetimes.
When the procedure terminates, the indication
shown previously turns off:
FG indicatestheneedtowashthemetal
greaselters.ThealarmistriggeredaftertheHood
has been in operation for 100 working hours.
FC indicates the need to change the
activatedcharcoallters,andalsotowashthe
metalgreaselters.Thealarmistriggeredafterthe
Hood has been in operation for 200 working hours.
FDelay function
Activate automatic switch-off with a 30’ delay.
Suitabletocompleteeliminationofresidualodours.
Can be activated from any position, and is disabled
by pressing the button or turning the motor off.
Displays the operating speed and the spot at the
bottomrightashesonceasecond.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Remote Control On and Off.
IR+Punto(2ashes)–RemoteControlOn.
IR+Punto(1ash)–RemoteControlOff.
GTurns the lighting system on and off at maximum
intensity.
HTurns the Courtesy Lighting on and off.
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Faber Bella 30 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info