368121

Faber vega electrische sfeerhaard Seite 3

3
Zoom out
Zoom in
Vorherige Seite
1/7
Nächste Seite
IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
- 3 -
General
Unpack the appliance carefully and retain the packaging for
possible future use, in the event of moving or returning the fire to
your supplier.
Before connecting the appliance check that the supply voltage is
the same as that stated on the appliance.
Please note: Used in an environment where background noise is
very low, it may be possible to hear a sound which is related to the
operation of the flame effect. This is normal and should not be a
cause for concern.
Electrical connection
WARNING - THIS APPLIANCE MUST BE EARTHED
This appliance must be used on an AC ~ supply only and the
voltage marked on the appliance must correspond to the supply
voltage.
Before switching on, please read the safety warnings and operating
instructions.
Transportation fixings - see Fig. 8
The transport bracket must be removed from the fire prior to
installation, remove the 2 screws and the bracket.
Warning: This bracket must be removed before installation; failure
to do this will result in having to uninstall the product in order to
replace a defective bulb.
Installation - see Fig.1
Ensure when building your fire into the surround that the front glass
can be removed at all times. (Refer to 'Lamp Replacement section')
As when this is removed it allows the customer to change the bulbs
and in the unlikely event that a service engineer needs to access
the interior components of the fire.
The fire is fixed from the rear. The 4 fixing brackets need to be fixed
to the rear of the fire, using the screws provided. There are slots in
these brackets to allow for adjustment of the fire in position. Please
use 4 suitable wood screws to firmly fix the fire to the surround.
Controls - see Fig. 2
Manual & Remote Operation.
The Standby switch must first be turned 'ON' to operate the fire
manually or by remote control.
To turn the flames on, press the I button.
To turn the flames off, press the O button.
To increase or decrease the brightness of the flames, use the
dimmer button or the buttons on the Remote Control.
To turn off the power the Standby Switch must be turned 'OFF'.
Remote control - see Fig. 7
The maximum range of use is ~ 15metres.
For details on the function please refer to the 'Controls' section in
this instruction leaflet.
Warning: It takes time for the receiver to respond to the transmitter.
Do not press the buttons more than once within two seconds for
correct operation.
Battery information - see Fig. 7
1.Slide open the battery cover on the back of the remote control
2.Install AAA batteries into the remote control
3.Replace the battery cover.
Discard leaky batteries.
Dispose of batteries in the proper manner according to provincial
and local regulations.
Any battery may leak electrolyte if mixed with a different battery
type, if inserted incorrectly, if all the batteries are not replaced at the
same time, if disposed of in a fire, or if an attempt is made to charge
a battery not intended to be recharged.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.
Lamp Replacement - see Fig. 3, Fig. 4 and Fig. 5
To gain access to the lamps first slide the outer glass up using the
suction cups and then lift the glass out from the bottom and slide it
out (Fig. 3).
Warning: The fuel effect is fragile, and should be handle with due
care.
Remove the fuel effect from the fire by removing the fixing screws
from the fuel bed and the 9-way connector and the fuel bed will slide
out of the fire. (Fig. 4).
Remove the rotisserie by carefully sliding the rubber connector off
the motor shaft. (Fig. 5)
Remove the defective lamp by unscrewing it as shown in (Fig. 5).
Replace with a 60W E14 SES Clear Candle lamp.
Take care not to over-tighten the lamp.
Refit the rotisserie, fuel bed and the outer glass.
Suction Cups - see Fig. 6
Place the suction cups onto the outer glass and close the handles
together as shown in (Fig. 6).
Recycling
For electrical products sold within the European Community.
At the end of the electrical products useful life it should
not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice in your country.
After Sales Service
Should you require after sales service or should you need to
purchase any spares, please contact the retailer from whom the
appliance was purchased or contact the service number relevant to
your country on the warranty card. Please do not return a faulty
product to us in the first instance as this may result in loss or
damage and delay in providing you with a satisfactory service.
Please retain your receipt as proof of purchase.
Important Safety Advice:
When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electrical shock
and injury to persons, including the following:
If the appliance is damaged, check with the supplier before
installation and operation.
Do not use outdoors.
Do not use in the immediate surroundings of a bath, shower
or swimming pool.
Do not locate the appliance immediately below a fixed
socket outlet or connection box.
This appliance is not intended for use by children or other
persons without assistance or supervision if their physical,
sensory or mental capabilities prevent them from using it
safely. Children should be supervised to ensure that they do
not play with the appliance.
In the event of a fault unplug the appliance.
Unplug the appliance when not required for long periods.
The appliance must be positioned so that the plug is
accessible.
If the supply cord is damaged it must be replaced by the
manufacturer or service agent or a similarly qualified person
in order to avoid a hazard.
3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Faber vega electrische sfeerhaard wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info