Bedienungsanleitung Fagor 6H-197A X (Seite 24 von 82) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch)

456758

Zoom out

Zoom in

Vorherige Seite

1/82

Nächste Seite

english

Troubleshooting

Safety

You can solve the following problems yourself:

4.1 4.1 The oven is not heating up. Check it is

plugged in and switched on and that the fuse

has not blown. Select a higher temperature

setting.

4.2 The interior light is not working. Change the

bulb or replace the fuse.

4.3 Smoke is coming out during cooking. Turn

the temperature down and/or clean the oven.

4.4 The pyrolysis cleaning process is not

being carried out. Ensure the door

is correctly closed. Locking system or

temperature sensor failure. Call the Technical

Service.

4.5 A beep is sounding. The selected

temperature setting has been reached. The

• The oven must be installed by an authorised

installer in accordance with the manufacturer’s

instructions and diagrams.

• The electrical installation must be dimensioned

for the maximum power indicated on the

reference plate and the electrical socket must

have a regulatory earth connection.

• The mains circuit supplying the oven must have

a single-pole cut-off switch with at least 3 mm

between contacts.

• If the power cord is damaged, it must be

replaced by the after-sales technical service or

by similarly qualiﬁ ed staff, to avoid hazard.

• Ensure the appliance is unplugged from the

mains before replacing the oven lamp, to avoid

electric shock.

• Do not use abrasive cleaning products or metal

scouring pads to clean the oven door, as they

could scratch the surface and cause the glass

to shatter.

remaining accessories so that they provide

leverage to lift up the glass (3.7.3). Remove

the glass (3.7.4), clean it and dry it with a

cloth (3.7.5). If necessary, remove the whole

glass panel unit inside the door. This unit

consists of either one or two glass panels,

depending on the model, with a black stop

in each corner. To remove them, place your

hand under the door and pull upwards

(3.7.6). When you have taken out the unit,

remove the stops to clean the glass panels

(3.7.7).

When the glass panels are clean (3.7.8) ﬁ t

them onto the rubber stops again, with the

stud facing upwards (3.7.9) and replace the

glass panels so that the letters “L” (left) and

“R” (right) are beside the hinges (3.7.10).

Lastly, place the remaining glass panel so

that the word PYROLYTIC can be read

(3.7.11). Remove the stops (3.7.12) and

close the door.

Warnings:

• Make sure the oven is switched off.

• Allow the glass to cool down before

removing it.

• Never use steam cleaning machines.

3.8 Cleaning the outside of the oven. Use

neutral cleaning products. Dry the oven well

with a soft cloth.

cooking cycle is complete.

4.6 The oven makes a noise after cooking.

This is normal, as the fan keeps running until

the temperature inside and outside the oven

is reduced.

4.7 Failure warnings.

Temperature sensor failure.

Door blocked (4.7.1).

Pyrolysis cannot be carried out.

Door block failure.

Software Failure

Power cut during cooking.

The oven automatically switches

off as it has been functioning for

several hours (4.7.2).

Do not try to repair the oven yourself. Call

the technical assistance service.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Fagor 6H-197A X Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info