34555
24
Zoom out
Zoom in
Vorherige Seite
1/46
Nächste Seite
THE INDUCTION HOB
Technical training
- 24 -
CU3-INDUCTION-003UK-10/05
GENERAL
OPERATION
After establishment of a voltage on both capacitors, the operation can be broken down into four
phases, as follows:
Phase 0
At rest
Transistors T1 and T2 act as two open
switches.
Capacitors C1 and C2 are supplied and
charged to a voltage V/2, the bridge is
balanced, there is no current in the inducer.
Phase 1
Transistor T1 is controlled and acts as a
closed switch.
A current flows through the inducer while C2 is
charged to +V and C1 is discharged.
Phase 2
Positive alternation
Both transistors are blocked but the inducer
forces a current flow.
C1 is charged again to V/2 and C2 is
discharged down to V/2. The bridge is
balanced again, => the current goes through 0
again
Phase 3
Transistor T2 is controlled and acts as a
closed switch.
A current flows in reverse direction in the
inducer while C1 is charged to +V, and C2 is
discharged.
Phase 4
Negative alternation
Both transistors are blocked but the inducer
forces a current flow.
This is the recovery phase, where C2 is
charged again to V/2, and C1 is discharged
down to V/2, the bridge is balanced again, =>
the current goes through 0 again
Return to step 1.
7.6. - Control
The entire operation is managed by a microprocessor.
On generation IX1, a specific board performed the control; the power was managed by another
board.
On generation IX2, these two boards have been soldered and have become indissociable.
On generations IX3, IX3WR and IX4000, power and control are entirely associated. So, the board
integrates: A 5 and 12 VDC clipping power supply (which is also the keyboard power supply),
the control part (in liaison with the control keyboard), the rectifier part, the inverter part, and
lastly, for board IX4000 and IX6, the filtering part.
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Fagor Brandt CU3 induction 003UK wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info