34555
41
Zoom out
Zoom in
Vorherige Seite
1/46
Nächste Seite
THE INDUCTION HOB
Technical training
- 41 -
CU3-INDUCTION-003UK-10/05
DIAGNOSTIC
14.3. - Tests and measurements on IX3, IX3WR, IX4000 and IX6
Where the action on the board is not desired, the diagnostic will be limited to the defective element.
Any action on the circuit shall be carried out after eliminating the causes that may be due to saucepans
or to a bad installation.
To avoid damaging the electronic components, never touch the circuit with your fingers.
14.3.1. - The test keyboards
During a diagnostic, it is necessary to know whether it is the
control keyboard or the power board, which is defective.
However, you must not omit the filter board, which includes two
fuse pads and the power supply relay. Generations IX3 on the
one hand and IX3WR, IX4000, IX6 on the other hand do not
use the same encoding process. It is therefore advisable to be
provided with two different test keyboards.
IX3 keyboard: 79X5460
IX3WR, IX4000 and IX6 keyboards: 79X9920
This keyboard will enable all the keyboard of each range to be replaced.
In event of degradation with use, baseplates can be replaced:
6-point baseplate (IX3) : 79X5461
8-point baseplate (IX3WR, IX4000, IX6) : 79x9921
14.3.2. - The IX3 and IX3WR filter board
These two generations have a different control but use the same filter board.
This board includes:
A direct output for the control power supply
A relay for the power supply
Two fuse pads
The fan power supply (via the relay).
In event of problem with power supply,
it is advised to check:
Whether 'fuse' pads are out of order
Whether the power relay is controlled (12VDC)
Whether the relay delivers 230VAC to the board.
Whether the relay delivers 230VAC to the fan
Note: Fuse pads are also present on the IX6
and IX4000 boards.
CAUTION : It is necessary to reinstall the glass-ceramic top to conduct the tests.
N L L N
Power relay
285 relay
coil
Outputs
after relay
Ground
screw
Fuse
pads
Fan
connector
41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Fagor Brandt CU3 induction 003UK wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info