Bedienungsanleitung Fagor CAT 44NG (Seite 13 von 104) (Englisch, Französisch, Portugiesisch, Spanisch)

485594

Zoom out

Zoom in

Vorherige Seite

1/104

Nächste Seite

Remove the water tank from the cof-

fee machine (Fig. 7).

Fill the water tank with fresh cold

water (Fig. 8).

Pour only fresh cold water in the water

tank. Never put in other liquids, e.g.

mineral water or milk.

Replace the water tank (Fig. 7). Press

the tank firmly in, to ensure that the

water tank valve opens.

If for instance, water has to be refilled

during coffee dispensing, the „Fill

water tank“ indicator (Fig. 3, k)

flashes, the display indicates «REFILL

WATER». Coffee preparation is inter-

rupted. Fill the water tank!

To always be sure of a rich coffee, with

a full aroma, you should:

• change the water in the water tank

daily,

• wash the water tank at least once per

week in normal washing-up water (not

in the dishwasher). Then rinse with

fresh water.

5.3 Switching on for the first time

When you place the machine in use for

the first time, the automatic switching

on process only continues if you have

selected the desired language.

Switch on the machine with the „On/

Off“ key (Fig. 3, h) (Fig. 9). The red

indicator light comes on

The machine is set at the factory to the

display language «ENGLISH».

To select a different language, proceed

with „Setting language“ page 45.

If you wish to select «ENGLISH»,

press the „OK“ key (Fig. 3, g). English is

now programmed.

After programming the display returns

automatically in the main menu to the

menu point «LANGUAGE».

To start the switching on process, press

the „Menu“ key (Fig. 3, f) or wait

ca. 30 sec. For the machine to auto-

matically start with the switching on

process.

The display briefly indicates «Xperta».

The machine now heats up (display

indication «UNIT HEATS») and sub-

sequently performs a rinsing cycle (dis-

play indication «UNIT RINSES»). On

completion of the rinsing cycle, the

machine is ready for use. The display

indication now appears according to

the basic setting.

5.4 Switching on the machine

Each time before switching on, make

sure there is water in the water tank

and replenish if necessary. The machine

requires water for the automatic rins-

ing cycles with each switching on and

switching off process.

Switch the machine on with the „On/

Off“ key (Fig. 3, h) (Fig. 9). The red

indicator light comes on, the display

indicates briefly «Xperta».

Immediately after being switched on

the machine runs through a set-up

cycle. The noises occurring are per-

fectly normal.

During the heating-up phase (ca.

60 seconds) the „Coffee machine heat-

ing“ indicator (Fig. 3, i) flashes (dis-

play indication «UNIT HEATS»).

After the operating temperature has

been reached, the coffee machine car-

ries out an automatic rinsing cycle.

(display indication «UNIT RINSES»).

The water flows into the drip tray. The

„Unit heats“ indicator (Fig. 3, i) lights

continuously.

The coffee machine is now ready to

use. The indication shown in the dis-

play depends on the last selected cof-

fee mode.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Fagor CAT 44NG Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info