14
•
Make sure that your oven has not suffered any damage during transport (deformed
door or door seal, etc.). If you see any signs of damage, contact your dealer before use.
•
Check the power voltage. If there is a PERMANENT undervoltage (200-210 volts), consult your
electrical installer.
•
Make sure that nothing obstructs the ventilation louvers at the back of the appliance.
•
Make sure the electrical plug will be accessible after installation.
•
Do not use your appliance immediately (wait approx. 1-2 hours) after transfer from a cold
place to a warm place as condensation may cause a malfunction.
Location
INSTALLATION
•
The appliance should be installed at a distance of 85 cm above the floor.
•
Place the oven on a flat and horizontal surface, away from any source of heat or steam.
•
Make sure that air may circulate freely around the oven.
•
Check all the characteristics and building in conditions in the user’s manual supplied with
the appliance.
•
Your installation must be protected by a 10 Amp thermal fuse.
•
It is mandatory to use a power point with a ground terminal, connected in accordance with
current safety regulations.
•
In your electrical installation, provide a device that is accessible to the installer, capable of
separating the appliance from the mains power and whose contact opening is at least 3 mm
at all of the poles.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
Electrical connection
Before connection
