Operation
32
A crevice nozzle [Q] and an upholstery nozzle [P] are
stored in the accessory chamber. To open the accesso-
ry chamber lid [J], press the two unlocking buttons at
the same time.
● Attach the required nozzle.
● Pull out the power supply cable by tugging on the plug un-
til the required length is reached. A yellow mark on the ca-
ble shows you that the maximum cable length has almost
been reached. The maximum cable length is shown by a
red mark on the cable. Never pull the cable out of the ap-
pliance beyond the red mark.
● To switch the vacuum cleaner on, press the ON-OFF foot
button [H]. If pressed again, the appliance switches off.
● Set the required suction level using the suction power re-
gulator [G].
Vacuum cleaning
WARNING!
Check the appliance and the power cable before use. Faul-
ty appliances may cause injury and should not be used.
When the dust bag or filters are full, or if the accessories
are blocked (hose, pipe, nozzle), the ‘change filter’ lamp
will shine [D]. To ensure correct analysis, the maximum
suction level [G] needs to be set and the floor nozzle needs
to be lifted from the floor.
In this case, change the dust bag or blocked filter or reme-
dy the blockage.
NOTE!
DG
H
Q
J
P
