10
The convector 2002 CT and 2002 CTFcan be used a standing or wall-mounted model.
Stand model:
Fit the two stands with the supplied screws to the bottom of the unit on the left and right.
Take care that the guide catch and the two guide lugs on the stand are inserted accura-
tely in the corresponding openings in the convector housing.
Wall-mounted model:
For mounting the wall holders select a place close (on the side) to a wall outlet – not in
the open or in damp rooms – and observe the minimum distance [F] to the wall, ceiling
and/or floor stated in the installation sketch (see page 3).
To install the wall holders hold these – according to the sketch on page 2 – at the inten-
ded place against the wall and transfer or mark the mounting holes with a pointed pencil.
Take care that the holders stand vertically and no electric cables or pipes can be drilled
though.
Fit the two wall holders with the supplied screws and wall plugs.
Remove the two stands (and keep them !), if you have previously used the unit as a stand
model and hook the convector in the wall holder until is audibly snaps into place.
Remove the convector: for this purpose pull the unit upwards out from the holders.
Plug the mains plug in the wall outlet. Turn the thermostat knob to the right (clockwise)
up to the stop and switch on with the operating mode switch:
Switch positions:
position [
−−
] = 750 watts heater
position [
==
] = 1250 watts heater
position [
−−
] + [=] = 2000 watts heater
position
±
= turbo blower ON
When the turbo blower is switched on, the room air is heated up quite quickly and uni-
formly.
Room thermostat
The heat intensity can be selected with a gliding movement by using the thermostat:
Position MIN. = lowest temperature / frost guard setting
Position MAX. = highest temperature
Turn the thermostat switch as far as possible in a clockwise direction. When the room rea-
ches the required temperature, then turn the thermostat in an anticlockwise direction, until
the appliance turns off. Should the room temperature reduce to below the required level
then the appliance will turn on again automatically.
Before use
Operation
2002CTF-8606.QXD 13.06.2006 10:56 Seite 10
