Bedienungsanleitung Falmec Astra Wall (Seite 13 von 80) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

661998

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

English

WARNING:

Install the hood away from sources of electromagnetic waves, as these could affect the correct operation of the electronic system.

Maximum operating distance: 5 metres. The maximum operating distance could be less than 5 metres in case of electromagnetic

interference by other equipment.

Light pushbutton on remote control: light on/off.

– and + pushbutton: increase/decrease speed (to start the motor press either the + or the – pushbutton).

Timer pushbutton: see instructions below.

Timer and ‘filter clogged’ alarm pushbutton

• This function allows the automatic turning off of the hood after running for 15 minutes at the speed previously set (the pushbutton

shows a flickering light).

• After about 30 hours of running the pushbutton indicates the need for washing the metal filters (the pushbutton shows a solid red

light). To disable the alarm press the pushbutton for a few seconds until the red light turns off. Then turn the hood off and on again

to check that the alarm has disappeared.

3. ELECTRONIC CONTROL PANEL

1: Timer/Alarm filters

The steady RED light indicates that the fat filter alarm is activated (after 30 hours), to deactivate this alarm and zero the meters,

maintain the Key pressed for 3 seconds.

Flashing RED light indicates that the timer function is activated. This function can only be activated if the motor is activated and run-

ning at any velocity when the Key is pressed (either prolonged or not). This function will cause the automatic switch-off of the hood

after 15 minutes.

With the Timer function activated, the hood can be switched-off by the operator in any case and the function will be deactivated.

The Timer function remains associated to a velocity. A change in the velocity, with the Timer function activated, will deactivate it.

2: 1st Velocity

When the LED is switched-off, non-prolonged pressing of the key will switch-on the hood at the 1

velocity and illuminate the respec-

tive LED. The function will switch-on when the Key is released.

When the LED is switched-off and another velocity is activated, pressing the Key will imply selection of the 1

velocity, switching-on

of the respective LED and switching-off of the LED associated with the velocity that was previously selected.

When the LED is on, pressing the Key will imply the switching-off the LED and MOTOR.

When the LED is switched-off, prolonged pressing (at least 3 seconds) of the Key will cause activation of the recirculation function.

During the recirculation function (with a duration of 24 hours), the LED will flash. From the activation of this function, the hood will

remain switched-on for one hour at the 1

velocity, after which it will switch-off for 3 hours and then reactivate for another hour.

These cycles are repeated until the timeout.

With this function activated, the other functions cannot be selected. To remove this function, keep Key 2 pressed for at least 3 sec-

onds.

3: 2nd Velocity

When the LED is switched-off and another velocity activated, pressing the Key (either prolonged or not) will imply the selection of

the 2

velocity, switching-on of the respective LED and switching-off of the LED associated with the velocity that was previously

selected.

When the LED is switched-off and no velocity activated, pressing the Key will have no effect.

When the LED is switched-on, pressing the Key 3 will have no effect.

To switch the hood off, it will be necessary to firstly select the 1

velocity and then repress the same Key.

4: 3rd Velocity

When the LED is switched-off and another velocity activated, pressing the Key (either prolonged or not) implies the selection of

the 3

velocity, the switching-on of the respective LED and switching-off of the LED associated to the velocity that was previously

selected.

When the LED is switched-off and no velocity activated, pressing the Key will have no effect.

When the LED is switched-on, pressing the Key 4 will have no effect.

To switch the hood off, it will be necessary to firstly select the 1

velocity and then repress the same Key.

5: 4th Velocity

When the LED is switched-off and another velocity activated, pressing the Key (either prolonged or not) implies the selection of the

velocity, switching-on of the respective LED and switching-off of the LED associated to the velocity that was previously selected.

When the LED is switched-off and no velocity activated, pressing the Key will have no effect.

When the LED is switched-on, pressing the key 5 will have no effect.

The forth velocity must remain on for a maximum of 7 minutes, after which, one must return to the third.

To switch the hood off, it will be necessary to firstly select the 1

velocity and then repress the same key.

6: Light - Remote Binding

Light: Briefly pressing key T6 will turn the light on and off. The T6 key will light up if the light is on.

Remote Binding (optional): With motor and light turned off, applying prolonged pressure on the T6 key will activate remote binding

mode. The T6 Key will flash for a maximum of 10 seconds. During flashing, at least one radio control key must be pressed. The func-

tion will deactivate upon completion of the 10 seconds, or earlier if a compatible remote control is detected.

Key pressure management:

Prolonged pressure = finger pressed on key for at least 3 seconds, the function activates during pressure.

Non-prolonged pressure = finger pressed on key for less than 3 seconds, the function activates upon its release.

Radio control (optional): Place the device far from sources of electromagnetic waves which could interfere with the range hood’s

Falmec Astra Wall Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info