Bedienungsanleitung Falmec Cielo (Seite 15 von 64) (Alle Sprachen)

709756

Zoom out

Zoom in

Vorherige Seite

1/64

Nächste Seite

ENGLISH

The yellow/green earth cable must not be cut oﬀ by the switch.

The Manufacturer declines all responsibility for failure to comply with the safety

regulations.

FUMES DISCHARGE

HOOD WITH INTERNAL RECIRCULATION FILTERING

In this model, the air passes through the zeolite-carbon ﬁlters

to be puriﬁed and recycled in the environment.

Ensure that the active carbon ﬁlters are assembled into the

hood, if not, install them as indicated in the assembly instruc-

tions.

In this version the check valve must not be assembled: remove it if it is

on the air outlet ﬁtting of the motor.

ASSEMBLY INSTRUCTIONS

only intended for qualied personnel

The hood can be installed in various congurations.

The generic assembly steps apply to all installations; for each case,

follow the specic steps provided for the required installation.

OPERATION

WHEN TO TURN ON THE HOOD?

Switch on the hood at least one minute before starting to cook to direct fumes

and vapours towards the suction surface.

After cooking, leave the hood operating until complete extraction of all vapours

and odours. By means of the Timer function, it is possible to set auto switch-oﬀ

function which will allow the hood to turn oﬀ automatically after 15 minutes of

operation.

WHICH SPEED IS TO BE SELECTED?

1st speed: maintains the circulation of clean air with low electricity consump-

tion.

2nd speed: normal conditions of use.

3rd speed: presence of strong odours and vapours.

4th speed: rapid disposal of odours and vapours.

WHEN SHOULD THE FILTERS BE WASHED OR REPLACED?

The metal ﬁlters must be cleaned every 30 hours of operation.

The zeolite-carbon ﬁlters must be reactivated every 18 months and replaced

every 3 years.

For further details see the “MAINTENANCE” chap.

TOUCH PUSHBUTTON PANEL

ON/OFF (Blue led steady on)

Motor on/oﬀ and Speed 1

ON/OFF (blue led ashing)

If pressed for more than 3 seconds, it activates the 24h cycle

(1h ON -> 3h

OFF -> 1h ON)

the function deactivates if:

- The motor turns oﬀ (key )

- After 24h

Speed 2 activation

Speed 3 activation

Speed 4 is only active for a few minutes, then speed 3 activates.

Light on/o

Short impulse: turn light on and oﬀ

Long impulse: change light tone from 2700K to 5600K

TIMER (red LED ﬂashing)

Auto switch-oﬀ after 15 min.

The function deactivates (red LED oﬀ) if:

- The motor turns oﬀ (key ).

- The speed is changed.

USING THE RADIO CONTROL

WARNINGS!:

Place the hood away from sources of electro-

magnetic waves (e.g. microwave ovens), which

could interfere with the radio control and with the hood

electronics. The maximum operating distance is 5 me-

tres, that may vary according to the presence of electro-

magnetic interferences.

Radio control operated at 433.92MHz.

The radio control consists of two parts:

- the receiver built into the hood;

- the transmitter shown here in the gure.

DESCRIPTION OF TRANSMITTING COMMANDS

Motor switch-on and speed increase from 1 to 4. Speed 4 is only

active for a few minutes.

DOWN

Speed decrease and motor switch-oﬀ.

Light ON-OFF

Short impulse:

turn light on and oﬀ

Long impulse:

change light tone from 2700K to 5600K

TIMER ON: The motor automatically switches oﬀ after 15 min.

The function is automatically disabled if the motor is switched oﬀ

( key)

Command transmission active

RADIO CONTROL CODE CHANGE

With only one radio control, go directly to point 2.

With several radio controls in the same room, a new code can be created by

following the procedure below.

Disconnect the power to the hood before starting the procedure.

1  CREATE A NEW CODE

The procedure is to be carried out on the radio control.

• Press LIGHT

and TIMER

simultaneously until the display starts ﬂash-

ing.

• Press DOWN

on the radio control: saving is conﬁrmed by three brief ﬂash-

es of the display. The new code cancels and replaces the previous default

code.

Reconnect the hood to the electrical power supply, making sure

that the lights and motor are o.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Falmec Cielo Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info