Bedienungsanleitung Falmec Domino 38 (Seite 13 von 48) (Deutsch, Englisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch)

709881

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

ENGLISH

SAFETY DEVICES ON THE COOKER

Safety shutdown

If a cooking area exceeds the maximum time for operation at the same power, it is auto-

matically switched o and the indication of the residual heat is shown.

To reset the cooking area, touch the necessary keys.

Power level

low

2 3 4 5 6 7 8 9 P

Maximum

duration of

operation in

hours

8.7 2.0 8.7 6.7 5.3 4.3 3.5 2.8 2.3 1.9 1.5

The cooker switches o automatically if one or more controls stay covered for more than

10 seconds.

To restore the proper operation:

- remove all objects from the control panel.

- clean the control panel.

- restart the cooker and the concerned area.

Overheating device

Before items of the cooker can overheat, the control reduces the used power by follow-

ing this procedure for protection measures:

- Deactivation of booster and power booster if turned on.

- Reduction of the power level set.

- Shutdown of the cooking area concerned.

On the display of the cooking area the message “E2” is displayed.

It is possible to restore the cooking area when the default message is o.

SAFETY INSTRUCTIONS

FOR ASSEMBLY

Install the cooker after installing kitchen cabinets and basis.

Make sure that worktops have been veneered with thermoresistant glue in

order not to suer deections or detachments.

It is forbidden to install the appliance on fridges or freezers, washing ma-

chines, dishwashers, or tumble driers.

ELECTRICAL SAFETY

The electrical system to which the cooker is to be connected must be in

accordance with local standards and supplied with earthed connection in

compliance with safety regulations in the country of use. It must also com-

ply with European standards regarding radio antistatic properties.

Make sure that it can’t be possible to touch the power cable of the cooker after it has been

built-in and that it is not subject to mechanical stress.

The socket used to connect the installed equipment to the electrical power supply must

be within reach: otherwise, install a mains switch to disconnect the hood when required.

Any changes to the electrical system must be carried out by a qualiﬁed electrician.

Do not try to solve the problem yourself in the event of equipment malfunction, but contact

the Dealer or an authorised Servicing Department for repairs.

When installing the cooker, disconnect the equipment by removing the

plug or switching o the main switch.

ELECTRICAL CONNECTION

(only intended for qualied personnel)

Disconnect the equipment from mains power network before carrying out

any operation on the cooker.

Make sure that electric wires inside the cooker are not disconnected or cut:

in the event of damage, contact your nearest Servicing Department.

Refer to qualied personnel for electrical connections.

Connection must be carried out in compliance with the provisions of law in force.

Before connecting the cooker to the mains power network, check that:

• the mains voltage corresponds with the voltage indicated on the data plate located

inside the cooker;

• the electrical system is compliant and can withstand the load (see the technical speciﬁ-

cations located inside the cooker);

• the power supply plug and cable do not come into contact with temperatures exceed-

ing 70 °C;

• the power supply system is eﬀectively and properly connected to earth in compliance

with regulations in force.

•

the socket used to connect the cooker is within reach.

In case of:

• devices ﬁtted with cables without a plug: the type of plug to use is a ''standardised'' one.

The wires must be connected as follows: yellow-green for earthing, blue for neutral and

brown for the phase. The plug must be connected to an adequate safety socket.

•

ﬁxed equipment not provided with a power supply cable and plug, or any other device

that ensures disconnection from the electrical mains, with an opening gap of the con-

tacts that enables total disconnection in overvoltage category III conditions.

Said disconnection devices must be provided in the mains power supply in compliance

with installation regulations.

The yellow/green earth cable must not be cut oﬀ by the switch.

The Manufacturer declines all responsibility for failure to comply with the safety regulations.

Connection of the cooker:

network Connection Cable

section

Power

cable

Switch

gauge

230V~

50/60Hz

Single-phase

+ N

3 x 2.5

mm²

H 05 VV - F

H 05 RR - F

25 A *

* calculated with the contemporary factor in compliance with EN 60 335-2-6.

POWER:

Feature

38 Plus

Total power

3500W

Front position

Rated power

1600W

2100W

Booster power

1850W 3500W

Back position

Rated power

2100W

Booster power (1/2)

2100/3000W

3500W

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Falmec Domino 38 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info