Bedienungsanleitung Fantasy Entice (Seite 21 von 24) (Englisch)

784930

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

For further inquiries, please contact our Customer Service Team

Email: ahsservice@watkinsmfg.com Phone: +1 760 598 6464 18

DRAINING OR WINTERIZING

Every three to six months, depending upon the

water condition, you need to renew your water.

CAUTION: READ THIS BEFORE DRAINING

YOUR SPA

• To prevent damage to the spa’s components,

TURN OFF SUBPANEL BREAKER

BEFORE DRAINING. Do not power back up

until your spa has been refilled with water.

• There are certain precautions to keep in mind

when draining your spa. If it is extremely cold,

and the spa is outdoors, freezing could occur

in the plumbing or the equipment.

• Do not leave the spa's shell (inside surface)

exposed to direct sunlight.

DRAINING YOUR SPA

• If draining for the first time, pull the hose

bib out a few centimeters (1") from the spa

(located in the recess under the spa, to the

side of the equipment access door).

• Unscrew and remove the drain cap.

• Attach hose bib to a garden hose and direct to

an appropriate draining area, keeping the hose

below the water

line.

• After your spa

is empty, clean

the shell and

filter cartridge.

See “Spa

Maintenance”

section.

• After cleaning, remove garden hose, replace

drain cap and push the hose bib back into the

recess.

• Follow the “Fill up and Start-up Instructions” on

page 14.

WINTERIZING YOUR SPA

If you plan to store your spa for the winter, you

must also use a wet-vac to clean out the water

lines to ensure they are free of any water. Water

left in the lines might freeze and damage the lines

and jets.

1. It will be necessary to remove all water from

the interior plumbing.

2. Remove the floating weir, basket, and filter

cartridge. Clean the filter cartridge and store

in a dry place. Attach the vacuum hose to the

vacuum side of the shop vac and thoroughly

dry the filter compartment.

3. Using the shop vac, remove the water starting

with the jets at the top and moving to the

ones at the bottom of the spa. NOTE: When

removing the water from jet openings, you

may notice suction coming from another jet.

With the help of a second person, block off any

suction from the other jet using a large rag or

cloth. This will help pull out the water that is

trapped deep inside the main line.

4. Thoroughly dry the spa shell with a clean

towel.

5. Using a funnel, pour Propylene glycol

anti-freeze into the filter suction fittings and

jet outlets. CAUTION: Use only Propylene

glycol as your anti-freeze. This is non-toxic.

NEVER use automobile anti-freeze since it

is toxic.

6. Remove the pump drain plug located on the

front of the pump housings. Allow all water to

drain out. Place the drain plug in a reclosable

plastic storage bag and store near the pump.

Replace the drain plugs on start-up.

7. Unscrew the suction/discharge pump and

heater unions and allow the water to drain.

Leave union loose.

NOTE: Tighten unions before filling spa.

8. Replace the equipment compartment door and

secure with screws.

NOTE: Damage caused by improper

winterizing will not be covered under warranty.

You may want to contact your local Dealer for

proper winterizing.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Fantasy Entice Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info